Makita RT0700C Manual De Instrucciones página 6

NOTE:
• Moving the tool forward too fast may cause
a poor quality of cut, or damage to the bit or
motor. Moving the tool forward too slowly may
burn and mar the cut. The proper feed rate will
depend on the bit size, the kind of workpiece
and depth of cut. Before beginning the cut on
the actual workpiece, it is advisable to make a sample cut on a piece of scrap lumber. This will
show exactly how the cut will look as well as
enable you to check dimensions.
• When using the trimmer shoe, the straight guide
or the trimmer guide, be sure to keep it on the
right side in the feed direction. This will help to
keep it flush with the side of the workpiece.
1
► 1. Feed direction 2. Bit revolving direction
3. Workpiece 4. Straight guide
Trimmer base (resin) (optional
accessory)
You can use the trimmer base (resin) as an optional
accessory as shown in the figure.
► 1. Thumb nut
Place the tool onto the trimmer base (resin) and tighten
the thumb nut at the desired protrusion of the bit.
For the operation procedures, refer to the operation for
the trimmer base.
2
4
1
Templet guide (optional accessory)
The templet guide provides a sleeve through which the bit
3
passes, allowing use of the trimmer with templet patterns.
Loosen the screws and remove the base protector. Place the
templet guide on the base and replace the base protector.
Then secure the base protector by tightening the screws.
1
2
► 1. Base protector 2. Screws 3. Screwdriver
Secure the templet to the workpiece. Place the tool on
the templet and move the tool with the templet guide
sliding along the side of the templet.
1
2
3
► 1. Straight bit 2. Base 3. Templet 4. Distance (X)
5. Workpiece 6. Templet guide 10 7. Base protector
NOTE:
• The workpiece will be cut a slightly different
size from the templet. Allow for the distance (X)
between the router bit and the outside of the
templet guide. The distance (X) can be calcu-
lated by using the following equation:
6 ENGLISH
4
10mm (3/8")
3
2
6
7
5