Ruark Audio R810 Guia De Inicio Rapido página 9

Setting up your system
1 Position your R810
To use your R810 on a sideboard or cabinet, fit the
supplied bar legs.
To use your R810 on its stand, assemble the stand and
carefully place the R180 on top, ensuring the rubber pads
on the stand fit into the dimples on the underside of the
cabiet.
Place your R810 on a level, firm surface, avoiding direct
sunlight and sources of heat or damp.
2 Fit the DAB/FM aerial
Fit the telescopic aerial to the DAB/FM aerial socket on
the back of your R810 and gently tighten it using the
supplied spanner.
NOTE: you do not need to fit the DAB/FM aerial if you do
not plan to listen to DAB or FM radio.
3 Connect to AC mains power
Plug the supplied mains power cord into the AC mains
inlet socket on the back of your R810 and then plug it
into an AC mains outlet.
If the supplied power cord does not fit your mains socket,
contact your Ruark dealer.
4 Setup wizard
If you're powering up your R810 for the first time or it
has not yet been set up, it will launch the setup wizard to
guide you through the setup.
Start by selecting your language and then follow the on-
screen instructions to configure your R810 and connect it
to your network.
To connect it to a network using Ethernet, simply plug
a network cable into the RJ45 Ethernet port on the back
panel.
To connect it to a Wi-Fi network, follow the setup wizard.
NOTE: if you connect your R810 to your network with
Ethernet, the setup wizard will skip Wi-Fi setup.
5 Navigate menus
To navigate menus and select options, rotate the
CONTROL KNOB until your preferred option is
highlighted, then press it to select the option.