Tabla de contenido
Idiomas disponibles
Idiomas disponibles
gb
The lithium-ion battery can be charged at any time
without reducing its service life. Interrupting the
charging procedure does not damage the battery.
When the battery is empty, the machine is switched off
by means of a protective circuit: The inserted tool no
longer rotates.
Do not continue to press the On/Off switch
after the machine has been automatically
switched off. The battery can be damaged.
The battery is equipped with a NTC temperature control
which allows charging only within a temperature range
of between 0 °C and 45 °C. A long battery service life is
achieved in this manner.
The charging procedure begins as soon as the mains
plug of the battery charger is plugged into a socket
outlet and the charge connector 17 is plugged into the
socket 16 on the bottom of the handle.
The battery charge-control indicator 5 indicates the
charging progress. During the charging process, the
indicator flashes green. When the battery charge-
control indicator 5 lights up green continuously, the
battery is fully charged.
During the charging procedure, the handle of the
machine warms up. This is normal. Disconnect the
battery charger from the mains supply when not using
it for longer periods.
The power tool cannot be used during the charge
procedure; it is not defective when inoperative during
the charging procedure.
Protect the battery charger against moisture!
Observe the notes for disposal.
Dust/Chip Extraction
Dusts from materials such as lead-containing coatings,
some wood types, minerals and metal can be harmful
to one's health. Touching or breathing-in the dusts
can cause allergic reactions and/or lead to respiratory
infections of the user or bystanders.
Certain dusts, such as oak or beech dust, are
considered as carcinogenic, especially in connection
with wood-treatment additives (chromate, wood
preservative).
Materials containing asbestos may only be worked by
specialists.
– Provide for good ventilation of the working place.
– It is recommended to wear a P2 filterclass respirator.
Observe the relevant regulations in your country for
the materials to be worked.
ELECTRICAL CONNECTION (FIG. D)
Battery Charge-control Indication
The status indicator on charger, consists of two LEDs:
LED
Continuous lighting, green
Continuous lighting, red
Temperature Dependent Overload Protection
When using as intended for, the power tool cannot be
subject to overload. When the load is too high or the
allowable battery temperature of 70 °C is exceeded,
the electronic control switches off the power tool until
the temperature is in the optimum temperature range
again.
Additionally, the battery charge-control indicator 5
flashes green and red at the same time until the On/
Off switch 9 is released.
ILLUSTRATED DESCRIPTION
1 SDS-PLUS tool holder
2 Dust protection cap
3 Locking sleeve
4 Selector switch for drilling/hammer drilling
5 Battery charge-control indicator
6 Indicator for right rotation*
7 Indicator for left rotation*
8 Rotational direction switch
9 On/Off switch
10 Universal bit holder*
11 Screwdriver bit*
12 Screwdriver bit with ball catch*
13 Drill bit with hexagon shank*
14 Drill bit with SDS-PLUS tool holder*
15 Handle (insulated gripping surface)
16 Socket for charge connector
17 Charge connector
*Accessories shown or described are not part of the
standard delivery scope of the product. A complete
overview of accessories can be found in our
accessories program.
4_OPERATING INSTRUCTIONS
PLACEMENT AND TESTING
Setting the Operating Mode
With the selector switch for drilling/hammer drilling 4,
the operating mode of the machine is selected.
Change the operating mode only when the
machine is switched off! Otherwise, the
machine can be damaged.
-
16
-
Capacity
Displayed when the
battery is
charged.
Displayed
when
the
battery is being charged.
Tabla de contenido
