GE AGM24 Manual Del Propietario E Instrucciones De Instalación página 5

wvvw.GEAppliances.com
COOLMode
Use the COOL mode with HIGH(F3),MED (F2)or
LOW(FI) tim for cooling.
Use tile
Increase •
/
Decrease •
pads to set tile desired temperature
between 60°F and 86°F in l °F increments,
An electronic them_ostat is used to maintain tile
room temperature, The (_)mpressor will cycle on and
off to keep the room at the set level of comfi)rt. Set
the them/ostat at a lower number and the indoor air
will become
cooler.
Set the them_ostat at a higher
number and tile indoor air will become wam/e_;
NOTE" ff the air conditioner is off and is then tumed on
while set to COOL, it will take approximately3 minutes
for the compressorto start and cooling to begin.
CoolingDescriptions
ForNormalCooling--Select tile COOL mode and
HIGH(F3)or MED (F2)fim with a middle
set
temperature,
ForMaximum
Cooling--Select
the COOL mode
and HIGH (F3)tim with a lower set temperatm'e.
ForQuieter& Nighttime
Cooling--Select
the
COOL mode and LOW (FI)tim with a middle set
temperature,
NOTE:If you switch from a COOL setting to OFFor to
a fan setting, wait at least 3 minutesbefore switching
back to a COOL setting.
Energy Saver
The energy saver switch controls the Lm.
O/_-The tim and compressor cycle on and off
together; This results in wider \m_iafions of room
temperature and hmnidity. Nommlly used when
the room is m_occupie(l.
NOTE:Thefan will
continue
to run for a short time after the compressor cycles off.
OFF
The tim runs all the time, while the
compressor cycles on and ofl_
This switch Inust
be set at OFFin
order to rise
tile tim settings (on tile mode control),
FAN Mode
Use the FAN at HIGH (F3), MED (F2) or LOW(F1) to Since tim only settings do not provide cooling,
provide air circulation and filtering without cooling, a temperature setting will not be displayed.
Vent Control
Tile vent control is located above tile control
panels.
When set at CLOSE, only the air inside the room
will be circulated and conditioned, _'hen set at
OPEN,
s olne inside air is exhausted outside.
To open the vent, pull the lever toward you.
To close it, push it hT.
Air Direction--Side-to-Side
The side-to-side air direction is a(!i usted 1)y moving
tile lever to tile left or fight.
Air Direction--Up and Down
Fingertip pressm'e on tile horizontal louve_
a(!justs tile air direction up or down.