Idiomas disponibles
Idiomas disponibles
Connect
Hose and Water Supply to Pump
IMPORTANT:
You must assemble nozzle extension
and attach all hoses before you start engine. Starting
engine without all hoses connected and water supplied
will damage pump.
•
Attach quick connect to your high pressure hose.
•
Uncoil high pressure hose and attach one end of
hose to the base of the spray gun with attached
quick connect. Pull down on the collar of the quick
connect, slide onto the gun and let go of collar. Pull
on hose and gun to be sure of a tight connection.
•
Attach other end of high pressure hose to the high
pressure outlet on the pump. Tighten by hand.
•
Turn ON the water (open supply valve completely).
•
Squeeze trigger on gun to purge pump system of
air and impurities.
,_
CAUTION!
Before starting the pressure
washer, be sure you are wearing adequate
eye protection.
•
Attach nozzle extension to spray gun. Tighten by
hand.
\
•
Before you connect your garden hose to the water
inlet, inspect the inlet screen. Clean the screen if it
contains debris or have it replaced if damaged. Do
not run the pressure
washer if the inlet screen
is damaged.
•
Connect garden hose to water inlet. Tighten by
hand.
CHECKLIST
BEFORE
STARTING
ENGINE
Review the unit to ensure you have performed all of
the following:
•
Check that hose reel fasteners are tight.
•
Check that oil has been added to proper level in
engine crankcase.
•
Add proper gasoline to fuel tank.
•
Check for properly tightened hose connections
(high pressure and water supply) and that there are
no kinks, cuts, or damage to the high pressure
hose.
•
Provide proper water supply (not to exceed 140°F).
•
Be sure to read "Safety Rules" and "Operation"
sections before using the pressure washer.
