Idiomas disponibles
Idiomas disponibles
INSTALATION AND OPERATION MANUAL FOR PC-P2HTE
6
5.3.2. INPUT/OUTPUT NUMBER
Input and Output Setting Mode and Connector
Setting
Mode
Indication
Input 1
Input 2
Output 1
Output 2
Output 3
Indication
00
Not Set
01
Room Thermostat (for Cooling)
02
Room Thermostat (for Heating)
03
Remote ON/OFF 1
04
Remote ON/OFF 2 (Operation)
05
Remote ON/OFF 2 (Stoppage)
06
Forbidding Remote Control after Manual Stoppage
07
Remote Cooling/Heating Change
08
Not Set
ATTENTION:
Write down the contents of the setting in the table printed on the holding bracket.
6. TIMER OPERATION PROCEDURE
6.1. SETTING THE ACTUAL TIME AND DAY
RUN/STOP
T EM P
TIMER
FAN SPEED
MODE
SCHEDULE OK
VENTI
↑↓
LOUVER DAY
SELECT
Input/Output Setting Mode (Mode Number "02")
Selection of Input/Output Number
HIGH
COOL
SERVi C E
A/C
HIGH
COOL
SERVi C E
A/C
Port
Remote ON/OFF 1
CN3 1-2
Forbidding Remote Control after Manual
CN3 2-3
Stoppage
Operation
CN7 1-2
Alarm
CN7 1-3
Thermo-ON for Heating
CN8 1-2
Input
1.Press ▽ DAY switch more than 3 seconds to
change the operation mode to actual time
setting mode. SET is indicated and the day
flickers. The days except the actual day are
indicated.
2.Press ▽ DAY switch until the actual day
flickers, then press OK switch. Selected day is
indicated and "time" flickers.
RESET
3.Press SELECT△▽ switch to adjust "Hour" ,
and when adjusted press OK switch. "Hour" is
indicated and "minutes" flickers.
4.Press △▽ switch to adjust "minutes", and
when adjusted press OK switch. The actual
time setting mode is finished and changed to
normal mode. "Minutes" is indicated and SET
is lighted off. "Seconds" starts from zero.
Input/Output Number
Select the input/output
number by pressing the
"SELECT"
or
<Example>
When selecting 01
(Output 1)
Setting at Shipping
Setting Item
switch.
Indication
03
06
01
02
06
Output
Not Set
Operation
Alarm
Cooling
Thermo-ON for Cooling
Heating
Thermo-ON for Heating
Total Heat Exchanger
Not Set
