Idiomas disponibles
Idiomas disponibles
INSTALATION AND OPERATION MANUAL FOR PC-P2HTE
2
In case of exposing Remote Control Cable.
1.
Fix the holding bracket onto the wall as shown
below
Fix the holding bracket with
the mark "↑UP" upward
Screw (Accessory)
When Using Switch Box.
.Run the cable into Field-Supplied JIS Box (JIS 8336 -
1998)
The following 5 types are available.
1. Switch Box for 1 Controller (without
Cover)
2. Switch Box for 2 Controllers (without
Cover)
3. Switch Box for 1 Controller (with Cover)
4. Switch Box for 2 Controllers (with Cover)
5. Outlet Box (with Cover)
Run the cable through the conduit tube in
the wall.
.Fix the holding bracket to the switch box
Fix the holding
bracket with the
mark "↑UP"
upward
Screw
(Accesory)
3. ELECTRICAL WIRING
3.1. STANDARD WIRING
Controller
Band
Ring core
Controller
cable
2. Attach the stopper to the cable at the inside of the
draw-out hole.
Band (Field-
Supplied)
REMOCON A
3. Lead the cable with its sheath peeled through the
groove
4. Peel the insulation at the end of the cable and clamp
the M3 solderless terminals
.Peel the insulation at the end of the cable and clamp
the M3 solderless terminals
REMOCON
A
Connect the terminals
.Mounting procedures.
1. Insert the hooks of the controller to the
holes on the top of the holding bracket.
2. Push the lower part toward the holding
bracket.
3. When the click sound is heard, the
controller is attached to the holding
bracket and the mounting work is
finished.
CAUTION:
Pay attention so that the cable may not be slack. If
the cable is slack as shown in the above figure, the
cable cord (especially the naked part) may be
clamped at the hole and it may cause a faulty
operation.
ATTENTION:
Attach the ring core (black) (accessory) when
-
installing the unit.
Insert the controller cable into the ring core 2 turns as
-
shown in the right figure before connecting to the
terminal board.
2
If wiring is 0.75 mm
is necessary to peel the outside
cover.
Fix the cable by using the band (accessory)
-
Cable
B REMOCON
REMOCON
B
