Ryobi A73TS01 Instrucciones

55 in. ACCESSORY TRACK
For use with RYOBI PTS01 Track Saw.
WARNING!
To reduce the risk of injury, user must read and understand
the operator's manual for their track saw and this instruction
sheet. Always wear eye protection with side shields marked
to comply with ANSI Z87.1. Ensure compatibility and fit
before using this accessory. Do not use this accessory if
a part is damaged or missing. If you are not comfortable
performing any of the functions described in these
instructions, take your unit to an authorized service center.
NOTE: Follow all guidelines and warnings in your track saw
operator's manual.
INCLUDES
See Figure 1.
27.5 in.Tracks (2), Connectors (4), and Wrench
ASSEMBLING TRACKS
See Figures 2 - 4.
Tracks can be used individually or assembled together to fit the
size of your project. Before use, all tracks should be assembled
and properly aligned, and the rubber cut strip should be cut.
To assemble tracks:
 Place the tracks upside down on a flat, level work space.
NOTE: Two tracks are provided with the saw. One has a
connector preinstalled and the other does not.
 Using the track wrench, loosen the screws securing the
connector to the track.
NOTE: Two wrenches are included with the saw, a small
one for the track and a large one for the blade.
 Align the tracks and slide the connector across the joint
and into the slot of the next track. Place the connector
approximately half way into each track and tighten the
screws to secure one side.
NOTE: The tracks are machined to fit together tightly along
the ends. However, before tightening the remaining screws,
place a 12 in. or longer straight edge, carpenter's square
or level along the long edges to make sure the pieces are
perfectly aligned. Skipping this step could compromise the
accuracy of the saw's performance.
 Align the long ends of both tracks against the straight edge,
carpenter's square or level. Holding both pieces together,
tighten the remaining screws to secure the connector.
NOTE: After tightening the screws, check again with the
straight edge to ensure the tracks are perfectly aligned.
Each track has a rubber cut strip running along the edge. Before
cutting a workpiece using the track, the rubber cut strip must
be trimmed away. Refer to "Using the Track" in the track saw
operator's manual.
Look for this accessory where you purchased this product
or call 1-800-525-2579:
Track Clamp Assembly ..................................... 089240074712
TTI CONSUMER POWER TOOLS, INC.
P.O. Box 1288, Anderson, SC 29622
Phone 1-800-525-2579 - www.ryobitools.com
A73TS01
Fig. 1
A
C
A - Wrench (clé, llave)
B - Track (rail, riel)
C - Connector (connecteur, conector)
C
Fig. 2
A
A - Track (rail, riel)
B - Connector (connecteur, conector)
C - Wrench (clé, llave)
D- Screw (vis, tornillo)
Fig. 3
A - Square (équerre, escuadra)
B - Wrench (clé, llave)
C - Screw (vis, tornillo)
Fig. 4
A - Rubber cut strip (bande de caoutchouc, tira de corte de goma)
B
D
B
A
A
A
B
C