Idiomas disponibles
Idiomas disponibles
EDGING
Asyou become familiar with use of
your e dger attachment,
you will b e
able todetermine
your own operating
pace. Conditions
such asdepth o fcut
and material being c ut w ill r egulate the
speed a nd time required foryour e dg-
ing job.
• Allow t he engine towarm upbefore
you begin e dging.
• Increase
the engine speed before
placing the blade i nthe cut. F or b est
results, run the engine atfull t hrottle
while c utting.
• Always work g oing a way f rom people
and solid o bjects such a swalls, large
stones, trees, automobiles,
etc.
• Be careful when e dging near trees o r
valuable
plants. The high s peed m etal
blade m ay c utroots and cause dam-
age tothe plants.
• Ifthe blade s talls, immediately
move
the unit b ack s lightly toallow the
blade torestart. Ifthe blade c ontinues
tostall, stop t he engine, disconnect
the spark plug, and inspect forblock-
age ordamage.
_ILWARNING;
Keep the blade area
clean. Always release the throttle trig-
ger, move the powerhead
ON/OFF
switch to the OFF position, disconnect
the spark plug (or disconnect
power-
head from power source), and make
sure the blade has completely
stopped turning before cleaning.
SETTING THE EDGING
DEPTH
,_/kWARNING:
Never attemptto
adjust the cut depth when the engine
is running. Always release the throttle
trigger, wait until the blade stops turn-
ing, move the powerhead
ON/OFF
switch to the OFF position, and discon-
nect spark plug (or disconnect
from
power source)
before making adjust-
ments.
Depth Adjustment_
,_
,no
.
i,
1. Loosen the depth adjustment
knob.
2. Slide the wheel to the desired posi-
tion.
• Raising the wheel will increase
the cutting depth.
• Lowering the wheel will decrease
the cutting depth.
3. Tighten the depth adjustment
knob
securely.
MAINTENANCE
SCHEDULE
WARNING:
Always stop unit and disconnect
spark plug wire (or discon-
nect powerhead
from power source) before performing
maintenance.
CARE AND MAINTENANCE
TASK
WHEN TO PERFORM
Check for loose fasteners and parts
Before each use
Check for damaged or worn parts
Before each use
Inspect and clean unit and decals
After each use
Check or replace blade
Every 5 hours of operation
GENERAL
RECOMMENDATIONS
The warranty on this attachment
does
not cover items that have been sub-
jected to operator abuse or negli-
gence. To receive full value from the
warranty, the operator must maintain
the edger attachment
as instructed
in
this manual.
CHECK
FOR DAMAGED
OR
WORN PARTS
Contact Sears Service Center for re-
placement
of damaged
or worn parts.
• Blade Shield - Discontinue
use of
edger if blade shield is damaged.
CHECK
FOR LOOSE
FASTENERS
AND PARTS
• Blade nut
• Fasteners
INSPECT
AND CLEAN
UNIT AND
DECALS
• After each use, inspect complete
unit for loose or damaged
parts.
Clean the unit and decals using a
damp cloth with a mild detergent.
• Wipe off unit with a clean dry cloth.
