Idiomas disponibles
Idiomas disponibles
AUXILIARYHANDLE
See Figure 4.
An auxiliary handle is packed with your drill for ease of
operation and to help prevent loss of control. The handle
can be rotated 360 ° and it can also be mounted on
opposite side for left hand use.
Note: For convenience and ease of starting threads, the
hex nut has been trapped inside the molded slot in the
auxiliary handle.
TO INSTALL:
•
Lock the switch trigger by placing the direction of
rotation selector in center position. See Figure 13.
•
Loosen wing screw enough to make ring of handle
large enough to fit over chuck.
•
Place ring of handle over the chuck. Note: Handle fits
in a groove behind torque adjusting ring.
•
Rotate handle to desired angle.
•
Tighten wing screw securely.
Note: If wing screw and wear plate is removed from
auxiliary handle, when reassembling, the markings on
the wear plate must be positioned as shown in Figure
4. This prevents the depth gage rod from slipping.
See Figure 4.
WINGSCREW
TO
TORQUE
TIGHTEN
KEYLESS
ADJUSTING
CHUCK
RING
TO
LOOSEN
RAISEDRIB
360°
ROTATION
GROOVE
AUXILIARY
MARKINGS ON
HANDLE
BACKSIDE
OFWEARPLATE
Fig. 4
To prevent possible loss of control, auxiliary handle
should be checked periodically for tightness. Do not
operate hammer drill with auxiliary handle loose.
TO ATTACH
BATTERY
PACK TO DRILL
See Figure5.
Note: Battery p ack isshippedin a lowchargecondition.
Therefore, i t must be chargedprior t ouse.Refertopage 12,
"CHARGING BATFERY PACK" for charging instructions,
•
Lock the switch trigger by placing the direction of
rotation selector in center position. SeeFigure
13.
•
Align raised ribs on battery pack with grooves on
bottom of drill, then attach battery pack to drill as
shown in Figure 5.
•
Make sure latch on battery pack snaps into place and
battery pack is secured to drill before beginning
operation.
RAISEDRIBS
LATCH
BATrERY PACK
Fig. 5
_.
CAUTION:
When attaching battery pack to your
drill, be sure raised ribs and grooves align properly
and latch snaps into place properly. Improper
assembly can cause damage to drill and battery
pack.
TO REMOVE
BATTERY
PACK FROM DRILL
See Figure 6.
•
Lock the switch trigger by placing the direction of
rotation selector in center position, See Figure 13.
•
Depress latch located on front of battery pack (1) to
release battery pack.
•
Pull forward on battery pack (2) to remove from drill.
DEPRESSLATCHTO
RELEASEBATrERYPACK
PULL
FORWARD
TO REMOVE
BATTERYPACK
Fig. 6
10
