Focal IW T3Y 200 Manual De Uso página 15

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 23
T3Y
U s e r m a n u a l
To facilitate the Focal-JMlab warranty,
it is now possible to register your product online at: www.focal.com/garantie
Thank you for purchasing a Focal product. Welcome to our High-Fidelity world. Innovation, tradition, excellence and pleasure
are our values; our one and only aim is to bring you a sound that is rich, pure and true. To get the most out of your product, we
recommend that you read the instructions in this booklet, then store it in a safe place to refer to in the future.
For your safety, follow the assembly instructions provided in this user manual.
Equipment required
• Drill (10mm drill bit);
• Hex screwdriver;
• Torx screwdriver;
• Ultra-flat key with torx bit (total height approx. 1 cm);
• Plastic door trim removal tool.
Important recommendations
These speaker drivers have been designed to be fitted in the factory location. Check that there is sufficient space between
the speaker driver and the protective grille.
• Keep the speaker drivers clear of any metal shavings and dust particles during the cutting process.
• Clean thoroughly before fitting the speaker drivers.
• Ensure that there are no objects positioned across the grille, as this could damage the speaker drivers.
• For the electrical disconnection, use the connector. Do not pull on the wires.
• Unclipping and reclipping the various parts must be done carefully.
• Excessive force may damage them.
Product positioning
The loudspeakers in the range have been designed to deliver the most faithful sound reproduction for any style of music.
Nonetheless, a few simple rules should be followed to optimise their performance and to guarantee good tonal balance and a
realistic sound image. We recommend placing the speaker drivers from the kit in the dedicated OEM locations (fig. 1 and 2).
Installation
The wiring method for the speakers in the IS T3Y 100 kit depends on the configuration of your car (see tab.).
• V1: No tweeter connection in the car (fig. A)
• V2: Tweeter not activated, Tweeter connector in footwell(fig. B)
• V3: Wired tweeter (fig. C)
• Identify the location of your midranges, as well as your tweeters, in the case of a 2-way component kit.
• Carefully disconnect and disassemble the original speakers.
• Fit the Focal speakers into the vehicle's factory locations, then connect them.
Installation details may vary depending on the model (see tab.). We recommend watching our online assembly tutorials. To
improve the performance of your system and eliminate parasitic sounds, we advise you to use the "B.A.M." acoustic insulation
kit sold by Focal.
SPECIAL PRECAUTIONS
Door trims
Once the door trim has been removed, it must not be placed on the floor. It must be placed on a raised surface to avoid
damaging it or damaging the cables.
Dashboard
When fitting the screw receivers, be careful not to drop the screws. This does not pose any particular risk, but it will be difficult
to find them again. If you need replacement screws, these are self-tapping screws 5mm in diameter and 15mm long (M5x15).
For the purposes of improvement or to take into account any legal or regulatory changes, FOCAL-JMLab reserves the right to modify the tech-
nical specifications of its products without prior notice. Where required, any images shown are for illustrative purposes only, and may differ
slightly from the products sold.
15 15
loading

Este manual también es adecuado para:

Icc t3y 100Is t3y 100Ic t3y 100