Idiomas disponibles
Idiomas disponibles
°
The nail holder must be set to the length of the nails being
used. Twist the spindle of the nail holder and position nail
holder up or down so that the edge of the nail holder is
aligned with the correct size indicator on the inside of the
magazine. Twist spindle to lock nail holder in place (see
Figure 3).
CAUTION:
Failure to adjust nail holder height may result in
damage to advance mechanism.
\
Nail Holder
Figure 3 - Adjust Nail Holder for Length of Nail
°
Remove rubber band or tape holding nail coil. Place coil
over the spindle of nail holder in magazine (see Figure 4).
Figure 4 - Load Coil into the Magazine
Unwrap coil so that second nail can be placed between
sides of feed jaw. The ram (Fig. 11, No. 20) may need to be
pushed up to fit in the first nail. Make sure that the nail
heads are positioned in the slot at the top of the nail feed
rack (see Figure 5).
Nail Heads Must be
Positioned in This Slot
.... ,Second
Nail Must Be
Positioned in Feed Jaw
Figure 5 - Load Nails into Feed Jaw
°
Carefully close the magazine cover first. Then close the
door and secure in position with the latch. Make sure the
tab in the door holds the magazine cover in place
(see Figure 6).
Figure 6 - Close the Magazine Cover and Door
NAILING
OPERATION
Refer to Figures 7 through 10 (page 5).
WARNING:
Read and follow all safety rules and operating
instructions in this manual and on warning label of tool before
using this tool. Keep this manual with the tool.
WARNING:
Do not use this tool without safety warning
label. If label is missing, damaged or unreadable, contact
Sears to obtain a new label.
WARNING:
Never operate tool unless contact trip is in con-
tact with workpiece. Do not operate tool without fasteners or
damage to tool may result. Never fire fasteners into the air
because fasteners may injure operator or others and damage
to tool may result.
°
Perform "Safety Mechanism Check" as described in the
Maintenance section (see page 6) prior to first use of tool
and on a daily basis thereafter.
4
