Removing The Packing Materials; Using The Power Switches And Switch Covers - Epson TM-J8000 Manual Del Usuario

Removing the Packing Materials

Remove the tape and laminated sheet that protect the printer
during shipping before turning on the printer.
1. First, pull the tape off the top of the printer cover, and open the
printer cover by pulling it forward slightly and lifting by the
front. Then remove the rest of the tape.
2. Remove the laminated sheet, and close the cover.

Using the Power Switches and Switch Covers

The TM-J8000 has one power switch in back and one in front. Both
switches must be on for the printer to function. Most users leave
the rear switch on and turn the printer on and off with the front
switch.
Note:
If you use both switches, turn on the rear one first, then the front one.
Turn off the front switch first, and after the POWER light goes off, turn
off the rear one.
Turning off the printer with the front switch allows the printer to cap the
head so that ink will not dry in the nozzles. Do not turn off the back
switch without turning off the front switch first. The POWER light
flashes while the heads are being capped and then goes off.
WARNING:
If an accident occurs with either
power switch cover attached, unplug
the power cord immediately.
Continued use may cause fire or
shock.
There are two power switch covers
— one for the front switch and one
for the rear switch. Illustrations
and show where to install the
2
switch covers. You can use either or
both of the enclosed power switch
covers to make sure that the power switch is not accidentally
pressed. If you need to turn the front switch on or off with the
cover attached, you can insert a thin tool into one of the holes in the
cover to operate the switch. Notice that the rear cover uses the
screw from the connector panel to fasten it in place.
1
TM-J8000 User's Manual 5
English
1
2