Kärcher CR 213 Manual De Instrucciones página 9

Fault Possible cause
Malfunctions be- Heater defective.
low 0°C.
Wash cards are Wash card inserted incorrectly.
pulled in and then
rejected, even
though the "Start/
Wrong station code on the wash card or wash
Stop" key is illu-
card issued by different wash station.
minated.
Wash card is defective.
Reader is dirty.
Wash cards are Indicator lamp is defective.
pulled in even
though the "Start/
Stop" key is not il-
luminated.
The "Start/Stop" Washing station is switched off
key is not illumi-
Fuse in the wash card reader defective.
nated; wash card
can be inserted
manually.
The "Start/Stop" The signal reads "ready to wash" or the red
key is not illumi- traffic light of the washing station not on even
nated; wash though the system is ready to operate.
cards are ejected
back out.
Cleaning the reader
Abrasion and dirty wash cards can cause
residue on the reader head.
 Moisten the cleaning card with alcohol.
 Reinsert the card into the wash card
reader several times.
 Check the function of the wash card
reader.
Spare parts
Only use accessories and spare parts
–
which have been approved by the
KÄRCHER. The exclusive use of origi-
nal accessories and original spare parts
ensures that the appliance can be oper-
ated safely and troublefree.
At the end of the operating instructions
–
you will find a selected list of spare
parts that are often required.
For additional information about spare
–
parts, please go to the Service section
at www.kaercher.com.
Warranty
The warranty terms published by the rele-
vant sales company are applicable in each
country. We will repair potential failures of
your appliance within the warranty period
free of charge, provided that such failure is
caused by faulty material or defects in man-
ufacturing. In the event of a warranty claim
please contact your dealer or the nearest
authorized Customer Service centre.
Please submit the proof of purchase.
Troubleshooting
Malfunctions at coin mechanism
Remedy
Heater resistors must be warm, otherwise, call
customer service.
Insert the wash card with the arrow on top and
pointing into the direction of the wash card read-
er.
Use a different wash card.
Clean the reader (see "Cleaning the reader").
Replace the light bulb.
Switch the washing station on.
Replace the fuse.
Reset the washing station. Observe the operat-
ing instructions for this. Call customer service if
necessary.
3
-
EN
By whom
Operator
Operator
Operator/Cus-
tomer Service
Operator
Customer
Service
Operator
Customer
Service
Operator/Cus-
tomer Service
9