Idiomas disponibles
Idiomas disponibles
ENGLISH
paper clip into the nozzle hole. Move it inwards and outwards until all dust and dirt is
removed. Fig. 6
-
Pour water through the nozzle hole into the nozzle in order to clean the dirt remains. To do
this, point a lighted garden hose at the nozzle for 30-60 seconds.
High pressure hose angle to the surface to be cleaned
When spraying water against a surface, the jet achieves maximum impact when sprayed
head-on. However, this type of impact tends to embed dirt particles into the surface, creating
the opposite cleaning effect to the desired. Therefore, the optimum angle for spraying water
against a surface is 45°. Spraying water at this angle improves the impact and allows it to be
combined with more efficient dirt removal.
Fig. 7
Distance from the surface to be cleaned
Impact and force of the water increases as the spray nozzle approaches the surface.
How to avoid damaging surfaces
-
A surface is damaged when the impact of the force of the water is greater than the
hardness of the surface. The impact force will vary according to the settings mentioned
above. Never use a direct jet on surfaces susceptible to damage. Avoid spraying windows
with the direct jet, as they may break.
-
Follow these steps to avoid damage to the surfaces:
-
Before pressing the trigger, move the spray nozzle to the fan spray position.
-
Follow the distance and angle instructions mentioned above.
-
Vary the angle of the jet, the type of jet and the distance from the surface to be cleaned
until efficient cleaning is achieved without damaging the surface.
3D Turboflip nozzle
The 3D Turboflip nozzle, also defined as a rotating nozzle, is a very effective accessory to
significantly reduce cleaning time. It must be used to clean in the turbo mode explained in the
previous section.
Cleaning process
Preparing the surface
Clear the area of furniture and check that windows and doors are securely closed. Also make
sure that plants and trees near the area to be cleaned are protected with a cloth.
Initial high-pressure rinse
Spray the area to be cleaned with water to clean any dirt that may have accumulated on the
surface. Before pressing the trigger, move the spray nozzle to the spray mode position and
H Y D R O B O O S T 1400 EASYMOVE
62
progressively move it to the desired spray position. In this way, you will avoid applying an
excessively direct jet on more delicate surfaces.
Final rinse
Start the final rinse from bottom to top. Make sure that the surface is well rinsed and that all
dirt has been removed.
Turning off
1.
Turn off the motor.
2.
Turn off the water supply.
3.
Once the product and the water supply have been turned off, press the trigger to
depressurise the device.
Warning
-
Do not turn off the water supply until the motor has been switched off, as this could cause
serious damage to the pump and motor.
-
Do not remove the high pressure hose from the machine while the system is being
pressurised. To depressurise the device, turn off the motor and water supply and press the
trigger 2 or 3 times.
Tips for extending the product shelf life
-
Do not use the product without water.
-
Do not use the product with hot water.
-
Before setting the spray nozzle pressure (high to low or low to high), release the trigger.
-
Never use the unit for more than 1 minute without spraying water.
4. CLEANING AND MAINTENANCE
-
Use only cleaning products specific for pressure washers.
-
The machine must be switched off and disconnected from the mains for cleaning or
maintenance.
-
Do not store the pressure washer outdoors or where it can freeze, the pump could be
severely damaged.
ENGLISH
H Y D R O B O O S T 1400 EASYMOVE
63
