Idiomas disponibles
Idiomas disponibles
2. Install the cylinder: lay the tray flat, with the side with all the threads facing upwards. Position the cylinder as shown in Figure
B. Prepare the screws to be fitted to the underside of the plate, by first fitting the split washer and then the single washer. Screw
in each screw and do not tighten them until all have been fitted.
3. Install the base: align the holes in the base with those in the cylinder. Position the assembly plate and secure the assembly
using the screws on the base/cylinder. Note that the foot must be installed in the same direction as the platter (Figure C).
Adjusting the table :
1. When using the table for the first time, remove the black screw on the cylinder. Do not remove the grey screw. Keep the
black screw in a safe place, as it may be useful for dismantling in the future.
Version Juin 2023
8
