INSTALLING THE MOUNTING BAR
3. Center Z Mounting Bar at cabinet location. Make sure cabinet will be mounted at least 1" (25mm) above fixtures. See the table below
for mounting bar height based on your specific cabinet model.
A
B
4. Make sure that the mounting bars are level when securing it to the wall. Use #10 X 2" screws [SS674] provided to attach the
mounting bar to the wall. Pre-drill a 3/32" (2 mm) pilot hole if going into a stud.
5. If no stud or structural member is available, use the provided wall anchors [203-1349], making sure that each cabinet is supported by at
least 2 anchors. Drill a 5/16" (8 mm) hole for wall anchors and insert the wall anchor into hole until the anchor flange is flush with the wall.
6. Use #10 X 2" screws [SS674] and tighten until there is a strong resistance. DO NOT OVER TIGHTEN.
6
SS674
© 2020 Robern, Inc. 701 N. Wilson Ave. Bristol, PA 19007 U.S.A.
800.877.2376
www.robern.com
Installation instructions
Cabinet Height
20
26
30
36
40
5/16"
(8 mm)
203-1349
(A) Overall Cabinet Height
20" (508 mm)
26" (660 mm)
30" (762 mm)
36" (914 mm)
39-3/8" (1000 mm)
4
(B) Height of mounting bar hole locations
18-7/8" (479 mm)
24-7/8" (632 mm)
28-7/8" (733 mm)
34-7/8" (886 mm)
38-1/4" (972 mm)
Part no. CB-209-1348 09/13/21
PL Portray Cabinet Ganging Surface Mount Installation
