Philips HR1364/00 Manual De Instrucciones página 2

EnGlIsH
Introduction
Congratulations on your purchase and welcome to Philips! To fully benefit from the
support that Philips offers, register your product at
www.philips.com/welcome.
General description (Fig. 1)
A Normal speed button
B Turbo speed button
C Motor unit
D Blender bar
E Whisk coupling unit (HR1364/HR1362 only)
F Whisk (HR1364/HR1362 only)
G Chopper coupling unit (HR1364/HR1363 only)
H Chopper blade unit (HR1364/HR1363 only)
I Chopper bowl (HR1364/HR1363 only)
J Beaker
Important
Read this user manual carefully before you use the appliance and save it for future
reference.
Danger
- Never immerse the motor unit in water or any other liquid, nor rinse it under
the tap. Only use a moist cloth to clean the motor unit.
Warning
- Check if the voltage indicated on the appliance corresponds to the local mains
voltage before you connect the appliance.
- Do not use the appliance if the plug, the mains cord or other parts are damaged.
- If the mains cord is damaged, you must have it replaced by Philips, a service
centre authorised by Philips or similarly qualified persons in order to avoid a
hazard.
- Never let the appliance run unattended.
- This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
- Children should be supervised to ensure that they do not play with the
appliance.
- Do not touch the blades, especially when the appliance is plugged in. The blades
are very sharp.
- If the blades get stuck, unplug the appliance before you remove the ingredients
that block the blades.
Caution
- Switch off the appliance and disconnect it from the mains before you change
accessories or approach parts that move during use.
- This appliance is intended for household use only.
- Do not exceed the quantities and processing times indicated in the table.
- Do not process more than three batches without interruption. Let the appliance
cool down to room temperature before you continue processing.
Electromagnetic fields (EMF)
This Philips appliance complies with all standards regarding electromagnetic fields
(EMF). If handled properly and according to the instructions in this user manual, the
appliance is safe to use based on scientific evidence available today.
Overheat protection
This appliance is equipped with overheat protection. If the appliance overheats, it
switches off automatically. Unplug the appliance and let it cool down for 5 minutes.
Then put the mains plug back into the wall socket and switch on the appliance
again. Please contact your Philips dealer or an authorised Philips service centre if the
overheat protection is activated too often.
Before first use
Thoroughly clean the parts that will come into contact with food before using the
appliance for the first time (see chapter 'Cleaning').
Preparing for use
1 Let hot ingredients cool down before chopping them or pouring them into the
beaker (max. temperature 80 °C).
2 Cut large ingredients into pieces of approximately 2 cm before processing
them.
3 Assemble the appliance properly before plugging it into the wall socket.
2
Using the appliance
Hand blender
The hand blender is intended for:
- blending fluids, e.g. dairy products, sauces, fruit juices, soups, mixed drinks and
shakes.
- mixing soft ingredients, e.g. pancake batter or mayonnaise.
- pureeing cooked ingredients, e.g. for making baby food.
1 Attach the blender bar to the motor unit ('click') (Fig. 2).
2 Immerse the blade guard completely in the ingredients (Fig. 3).
3 Switch the appliance on by pressing the normal or turbo speed button.
4 Blend the ingredients by moving the appliance slowly up and down and in
circles (Fig. 4).
Chopper (HR1364/1363 only)
The chopper is intended for chopping ingredients such as nuts, meat, onions, hard
cheese, boiled eggs, garlic, herbs, dry bread etc.
The blades are very sharp! Be very careful when handling the blade unit, especially
when removing it from the chopper bowl, when emptying the chopper bowl and
during cleaning.
1 Put the chopper blade unit in the chopper bowl (Fig. 5).
2 Put the ingredients in the chopper bowl.
3 Put the coupling unit onto the chopper bowl (Fig. 6).
4 Fasten the motor unit onto the chopper bowl ('click') (Fig. 7).
5 Switch the appliance on by pressing the normal or turbo speed button.
If the ingredients stick to the wall of the chopper bowl, loosen them by adding
,
liquid or using a spatula.
Always let the appliance cool down after chopping meat.
,
Whisk (type HR1364/HR1362 only)
The whisk is intended for whipping cream, whisking egg whites, desserts etc.
1 Connect the whisk to the coupling unit (Fig. 8).
2 Connect the coupling unit to the motor unit ('click') (Fig. 9).
3 Put the ingredients in a bowl.
Tip: Use a large bowl for the best result.
4 Immerse the whisk completely in the ingredients and to avoid splashing start
processing at normal speed by pressing the normal speed button. (Fig. 10)
5 Continue with turbo speed after approx. 1 minute by pressing the turbo speed
button.
Cleaning
1 Unplug the appliance and detach the accessories before cleaning.
2 Clean the beaker, the chopping bowl (HR1364/HR1363 only), the chopper
blade unit(HR1364/HR1363 only) and the whisk without coupling unit
(HR1364/HR1362 only) in the dishwasher or in warm water with some
washing-up liquid.
It is recommended to remove the rubber ring from the chopper bowl before
cleaning.
3 The blade unit of the blender bar and the whisk can also be cleaned while
still attached to the motor unit by immersing them in warm water with some
washing-up liquid and letting the appliance run for a while.
4 Wipe the motor unit, the whisk coupling unit (HR1364/HR1362 only) and the
chopper coupling unit (HR1364/HR1363 only) with a moist cloth.
Do not immerse the motor unit, the whisk coupling unit (HR1364/HR1362 only)
and the chopper coupling unit (HR1364/HR1363 only) in water.
Environment
- Do not throw away the appliance with the normal household waste at the end
of its life, but hand it in at an official collection point for recycling. By doing this
you help to preserve the environment (Fig. 11).
Accessories
You can order a direct-driven mini chopper (under service code number 4203 035
83450) from your Philips dealer or a Philips service centre as an extra accessory for
the HR1364, HR1363, HR1362 and HR1361.
Use the quantities and processing times of the mini chopper for this accessory.
4222.005.0100.1