Kenwood CPP40 Instrucciones página 3

Only use the appliance for its intended
l
domestic use. Kenwood will not accept
any liability if the appliance is subject to
improper use, or failure to comply with these
instructions.
important
Do not press too hard on the cone or
l
run for longer than 10 minutes - you
may damage your juicer.
Use your new Kenwood Citrus
Juicer to squeeze the juice from
citrus fruit eg oranges, lemons, limes
and grapefruits.
before plugging in
Make sure your electricity supply is
l
the same as the one shown on the
underside of the appliance.
This appliance conforms to EC
l
Regulation 1935/2004 on materials
and articles intended to come into
contact with food.
before using for the first time
1 Wash the parts: see 'cleaning'.
key
a dust cover
b small cone
c large cone
d strainer
e juice bowl
f anti-drip spout
g drive shaft
h power unit
i cord storage
to use your citrus juicer
1 Fit the bowl e to the power unit.
2 Place the strainer d inside the bowl,
then add the cone.
The small cone is most suitable for
l
small fruits such as lemons and
limes.
To use the larger cone fit it over the
l
smaller cone 1. The larger cone is
most suitable for larger fruits such as
oranges and grapefruits.
3 Put a suitable glass or jug under the
spout f.
4 Push the drip stop down ready for
juicing 2.
5 Cut the fruit in half and place one
half on the cone. The juicer will
operate automatically.
During use the cone may change
l
the direction it rotates. This is normal
and ensures that the maximum
amount of juice is squeezed out of
the fruit.
To help with juice extraction, move
l
the fruit from side to side.
When juicing large quantities, empty
l
the strainer regularly to prevent the
build up of pulp and seeds.
For best results store and juice the
l
fruit at room temperature and hand
roll on a worktop before juicing.
6 To stop the juicer, lift the fruit from
the cone. Lift the drip stop up 3
before removing the jug or glass.
cleaning
Always switch off, unplug and
l
dismantle before cleaning.
Replace the dust cover a after use.
l
power unit
Wipe with a damp cloth, then dry.
l
Do not immerse in water.
l
Store excess cord in the storage
l
area at the back of the power
unit .
i
other parts
Wash in hot soapy water, then dry.
l
Alternatively they can be washed on
l
the top rack of your dishwasher.
3