Idiomas disponibles
Idiomas disponibles
2. CONTROL MODULE
1.
2.
3.
4.
Parts of the control module
1. Display
When the pump is started, the display shows [
then shows the current consumption in amperes (A).
2. Presence of voltage
Indicates that the module is operative. Lights only turns on in automatic mode.
3. Factory diagnostics (reserved)
4. Pump ON
Indicates that the pump is running.
5. Motor underload
• Flashing LED: Motor underload detection (I.min).
• Fixed LED: Motor underload protection has tripped.
6. Motor overload / Phase failure
• Flashing LED: Motor overload detection (I.min) or phase failure.
• Fixed LED: Tripping of the motor overload protection or phase failure
protection.
7. Low level
• Flashing LED: Automatic reset in progress or manual reset by means of
MAN-STOP(RESET)-AUTO switch.
• Fixed LED: Lack of water.
8. Underload adjustment (Imin)
Knob for setting the motor underload protection.
9. Overload adjustment (Imax)
Knob for setting the motor overload protection.
10. Restart adjustment time (restart)
Knob to adjust the engine restart time after a lack of water.
8.
9.
ZERO
TZ1
I.min
I.max
5.
6.
10.
0FF
restart
7.
] for a few seconds and
8. 8 . 8 .
25
