Idiomas disponibles
Idiomas disponibles
Downloaded by: pm_clarallort on 13-07-2023 15:30 CEST
vibration or other defects stop the appliance
immediately. Then check the problem and /
or proceed as we describe on Anomalies and
Repair clause.
- The appliance can be used on surfaces such
as: wood, cardboard, plastic, plaster, etc.
- Use suitable detectors to determine if utility lines
are hidden in the work area or call the local utili-
ty company for assistance. Contact with electric
lines can lead to fire and electric shock. Damag-
ing a gas line can lead to explosion. Penetrating
a water line causes property damage or may
cause an electric shock.
- Do not touch the bit during or immediately after
operation. The bit becomes very hot during
operation and could cause serious burns.
- Do not use the power tool with a damaged cord.
Do not touch the damaged cord and pill the plug
- Warning: Reduce the working time to avoid risks
related with too much vibration.
DESCRIPTION
A.
SDS Plus Chuck
B.
Bit Holder ring
C.
Rotary stop Lever
D.
Drilling/hammer drilling switch
E.
On/Off Switch
F.
Auxiliary handle
G.
Grease cover
H.
Electronic regulation control
I.
Dust collector
J.
Drill Chuck
K.
SDS-plus adaptor
If the model of your appliance does not have the
accessories described above, they can also be
bought separately from the Technical Assistance
Service.
INSTALLATION
- Auxiliary Operation (Fig. 1).
- Operate the appliance only with the auxiliary
handle.
- Turn the auxiliary handle (F) in clockwise.
- Set the auxiliary handle on the appliance into
the required position.
- Tighten the auxiliary handle (F) in counter clock-
wise direction.
INSTRUCTIONS FOR USE
BEFORE USE:
- Make sure that all the product's packaging has
been removed.
- Prepare the appliance according to the function
you wish to use:
- Fitting the working tools: (Figs. 1, 2).
- Unplug the appliance from the mains.
- Only use tools with SDS-plus shaft.
- Clean and grease the shaft of the tool.
- Insert the tool by moving the sliding ring (B)
back. Now the SDS-plus chuck is open.
- Install the tool in. Turn it slightly until it can be
pushed in all the way and you can feel it engag-
es into place.
- Release the sliding ring (B). Now the tool is
locked.
- SDS-plus adapter for drilling in wood or metal
(Fig. 3).
- Unplug the appliance from the mains.
- Fit the SDS-plus adapter (K) into the SDS-plus
chuck as described above "fitting the working
tools"
- Screw the Drill Chuck (J) on the mounting shaft
and Screw the mounting Screw.
- Open the drill chuck (J), whilst the device is
completely switched off.
- Insert the cilindrical drill bit, or other tool/ ac-
cessory required for the task, into the chuck (J).
In order to obtain a secure fastening of the bit,
insert the bit as far as you can into the chuck.
- Close the drill chuck (J), whilst the device is
completely switched off.
- Don't use rotation with hammering when the
SDS-plus adaptor + drill chuck is installed on
the device.
- Using the dust collector (Fig. 2).
- The dust collector is used for drilling into ceil-
ings.
- Side the dust collector (I) onto the shaft of the
bit and mount the bit as described above "Fitting
the working tools".
- Electronic speed control (Fig. 1).
- The speed of the appliance can be regulated
by using the speed regulator control (H). This
function is very useful, as it makes it possible to
adapt the speed of the appliance to the type of
work that needs to be done.
- If the appliance works continuously at low
speed, working life of the appliance will be
reduced considerably.
