Idiomas disponibles
Idiomas disponibles
Installation Instructions
MOUNTING SYSTEM INSTALLATION
Pick a location under the sink to mount the system.
Location should be easily accessible, with 4" of
clearance between the bottom of the filter canisters
and the floor or bottom of the cabinet; any less will
result in difficulty of removing filter canisters. Allow
enough space on either side of the system for the
tubing connections. System should be mounted at
least 7" from front of cabinet to allow proper routing of
tubing.
SCREW INSTALLATION
1. Remove the top cover of system.
System
Top Cover
2. Screws should be placed a minimum of 15 inches
above the bottom of the cabinet or floor where the
system is to be mounted.
NOTE: Any distance lower may result in filter
canisters interfering with the floor when
removed.
31-6000260 Rev. 3
3. Use the system as a template to mark screw hole
Screws
15 inches
4. Hang system on screws and tighten until system is
5. Install top cover onto system.
6. Install 4 foot long yellow tube into inlet (left side) of
7. Install 4 foot long blue tube into outlet (right side) of
8. Remove shrink wrap from filters and install in
9. Turn on water supply valve and check for leaks.
10. Perform Flush Procedure as described on page 8,
locations where the screws are to be installed.
Install screws into the wall, leaving 3/16 inch
clearance between the head of the screw and wall
(drill pilot holes if needed). Use anchors if mounting
to drywall. Anchors require a 1/4" hole.
3/16 inch
Screw
held firmly.
system (inlet and outlet are labeled on top of the
system).
system. Pull firmly on tubes to make sure they are
secure.
system by turning approximately 1/3 turn until
locked into place. Filter will raise up as it is turned.
Filter label will be centered and facing forward when
fully installed.
NOTE: System may exhibit low flow or no flow
at all if the filter is not fully installed.
steps 3-6.
Wall
7
