Idiomas disponibles
Idiomas disponibles
Installation (continued)
7
Installing the plaster guard
and cartridge
□
Install the o-rings (1) and cartridge (2) onto the
valve body (D). Make sure the cartridge (2) is
installed correctly. Slide the bonnet (3) over the
cartridge (2) and thread them onto the valve
body (D). Tighten bonnet (3) securely with
adjustable wrench until the o-ring (1) on the
valve body (D) is covered completely.
Install the sleeve (4), and hand-tighten it only.
□
Place the plaster guard (J) onto the valve
body (D) and secure with the screws (I).
NOTE: Be sure to position the plaster guard (J) correctly
onto the valve body (D), with the side marked "SHOWER"
facing upward.
3
4
J
I
D
1
2
8
Removing the plastic cap
□
Before installing the escutcheon (E), remove the
plastic cap (1) from the valve body (D) by twisting
the cap in a clockwise direction.
1
9
Adjusting the temperature
NOTE: The limiter on the valve can be set to allow partial
or full access to hot water by limiting how far the handle
can be turned to the hot side of the valve. The limiter is
typically set at the factory to allow only warm water to pass
through the valve. Follow the directions in this section if you
wish to adjust the amount of hot water that is allowed
through the valve. If you do not wish to adjust the amount
of hot water that is allowed through the valve, proceed to
the step 11, and skip over the step 10 (A, B, C, D).
A
Removing the sleeve and
inverter
□
Unscrew the sleeve (1) from the valve body (D).
□
Unscrew the screw (2) from the inverter (3),
and then remove the inverter (3) from the
valve body (D).
2
1
11
Please contact 1-855-HD-GLACIER for further assistance.
D
3
HOMEDEPOT.COM/GLACIERBAY
D
