Boiling Water; Descaling The Kettle - Dometic MCK750 Instrucciones De Uso

MCK750
7.2

Boiling water

➤ Set down the water tank in a central position on the locking tongues (fig. 3 1, page 3).
➤ Turn the water tank 90° anti-clockwise.
The lock (fig. 3 2, page 3) must engage audibly.
➤ Press the two locking buttons in the lid (fig. 4 2, page 4) together and open the lid.
➤ Pour the desired amount of water into the tank.
➤ Close the lid.
✓ The lid engages audibly.
➤ Check that the voltage specification on the type plate corresponds to that of the energy
supply.
➤ Connect the DC plug to a DC socket.
➤ Press the On/Off switch (fig. 1 3, page 3) to start the boiling procedure.
✓ The control lamp (fig. 1 4, page 3) is lit up during the boiling procedure.
✓ The kettle is automatically switched off when the water boils.
You cannot switch off the kettle by hand.
➤ To remove it, press the lock (fig. 5 1, page 4) and turn the water tank 90° clockwise.
7.3

Descaling the kettle

To ensure quick heating and extend the service life of the heater coil, the kettle has to be descaled
after boiling approx. 30 – 40 times. Noticeable signs that descaling is necessary are:
• Prolonged boiling time.
• Loud boiling noises,
• Visible deposits on the base.
A
NOTICE!
For health and ecological reasons, use only biological means of descaling. Purchase
these means only in specialist stores.
Do not under any circumstance use hydrochloric or sulphuric acid for descaling.
I
NOTE
Observe the application and dosing recommendations of the manufacturer of the
decalcifier.
➤ Boil water two to three times with the decalcifier.
➤ Boil clear water two to three times.
➤ Let the kettle cool down for about 10 minutes.
Do not pour any water into the hot kettle during this time.
➤ Rinse the water tank and lid with hot water.
EN
Using the kettle
9