Installation; Unpack The Machine; Unfold And Adjust The Lower Handle; Install The Upper Handle - Echo DLM-310/35P Manual Del Operario

EN
7

INSTALLATION

Do not use accessories that are not recommended by
the manufacturer.
Do not put in the safety key or the battery pack until
you finalised the assembly of all the parts.
7.1

UNPACK THE MACHINE

Read the operator's manual carefully to ensure that
you assemble the product correctly. Using a product
that has been incorrectly assembled could lead to an
accident or serious injury.
• If parts of the machine are damaged, do not use
the machine.
• If you do not have all the parts, do not operate the
machine.
• If parts are damaged or missing, contact your
dealer.
1. Open the package.
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and packing material in compliance
with local regulations.
7.2 UNFOLD AND ADJUST THE
LOWER HANDLE
Figure 2.
1. Pull up and back the lower handle to lift the handle
into operation position. Make sure that the handles
click into position correctly.
2. Tighten the lower handle with the quick-release
levers on the two sides.
Make sure that the two handles are in the same
position.
Do not damage the cables when you fold or unfold the
handle.
WARNING
WARNING
WARNING
WARNING
NOTE
WARNING
English
7.3

INSTALL THE UPPER HANDLE

Figure 3.
1. Align the holes in the upper handle and the lower
handle.
2. Put the bolts through the holes.
3. Tighten the knobs onto the bolts.
4. Do the same operation on the other side.
7.4

INSTALL THE GRASS CATCHER

Figure 4.
1. Remove the mulch plug.
2. Open the rear discharge door and hold it.
3. Hold the the grass catcher by its handle and put the
hooks over the slots.
4. Close the rear discharge door.
7.5

INSTALL THE MULCH PLUG

Figure 5.
1. Remove the grass catcher.
2. Open the rear discharge door and hold it.
3. Hold the mulch plug by its handle and fit it in the
discharge chute.
4. Close the rear discharge door.
7.6

SET THE BLADE HEIGHT

The machine can be set to different blade heights.
Figure 6.
1. Pull the height adjustment lever rearward to
increase the blade height.
2. Pull the height adjustment lever forward to decrease
the blade height.
7.7 INSTALL THE BATTERY PACK
Figure 7.
• If the battery pack or charger is damaged, replace
the battery pack or the charger.
• Stop the machine and wait until the motor stops
before you install or remove the battery pack.
• Read, know, and follow the instructions in the
battery and charger manual.
1. Open the battery door.
2. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
3. Push the battery pack into the battery compartment
until the battery pack locks into place.
4. When you hear a click, the battery pack is installed.
8
WARNING