Idiomas disponibles
Idiomas disponibles
PUMP ELECTRICAL CONNECTIONS
5. Connect the green ground wire from the
power supply to the remaining green ground
screw in the pressure switch and re-attach
the pressure switch cover.
PUMP PRIMING AND STARTUP
PRIMING
CAUTION: All pumps must be primed
(filling the cavity with water) before they are
first operated. This may take several gallons
of water, as the suction pipe will be filled in
addition to the cavity of pump.
1. Remove pipe plug or pressure gauge (not
included) at the top of the discharge tee and
the vent plug in front of the discharge tee.
2. Slowly fill the discharge tee with water until
water overflows the vent plug opening.
Replace the vent plug loosely.
NOTE: It will take several minutes to fill pump
and suction pipe completely.
3. Be sure entire suction pipe is filled when
priming. Depending on the length of suction
pipe, many gallons will be needed to fill the
entire system.
Copyright © 2019 Star Water Systems. All rights reserved.
14
5
Ground Screws
Wire from
power
supply
Green
ground
wire
1
Suction
Pipe
2
Vent plug
opening
Vent plug
3
Suction
Pipe
Wire
from
motor
Priming plug
or pressure
gauge
Vent plug
Priming plug
opening
Discharge Tee
