Idiomas disponibles
Idiomas disponibles
TANK TO HOUSE CONNECTION
5. Attach the pipe from the pump to the tee
installed in Step 4. Then, from the tee,
install 3/4 in. pipe and optional shut off
valve (not included) to connect tee to
house plumbing.
6. IMPORTANT: Air pressure in the tank
must be 2 PSI lower than the "cut-in" of
the pressure switch. Pump has a 20/40
PSI pressure switch, so tank pressure
must be set at 18 PSI. Locate the air
valve/stem on the tank and check
pressure with a tire gauge (not included).
If air needs to be removed, press down on
valve to bleed off air. Use a tire pump or
air compressor to add air if needed.
PUMP ELECTRICAL CONNECTIONS
WARNING:
•
Always disconnect pump from electricity before performing any work on the motor.
•
Under-sized wiring can cause motor failure and even fire. Use proper wire size specified in the
Wire Size Chart.
•
Replace damaged or worn wiring cord
immediately.
•
Do not kink power cable and never allow
the cable to come in contact with oil,
grease, hot surfaces, or chemicals.
•
The pump must be properly grounded using
the proper wire cable with ground.
CAUTION:
•
Protect the power cable from coming in
contact with sharp objects.
•
All wiring should be performed by a qualified
electrician in accordance with the National
Electric Code and local electric codes.
•
Connect the pump to a separate electrical
circuit with a dedicated circuit breaker. Refer
to the Wire Size Chart for proper fuse size.
Copyright © 2019 Star Water Systems. All rights reserved.
12
5
Glue
From Pump
IL1369
6
Air Valve/Stem
WIRE SIZE CHART
Recommended Copper Wire
Distance from
Motor to Meter
115 V 230 V 115 V
14
0-50 Ft.
50-100 Ft.
12
100-150 Ft.
10
150-200 Ft.
8
200-300 Ft.
*
Fuse Size (Amps)
15
(*)
Not economical to run in 115 V, use 230 V
Shut off valve
To House
Plumbing
Reducer
Bushing
Tank
Tire gauge
and Fuse Sizes
Single Phase Motors
1/2 HP
3/4 HP & 1 HP
230 V
14
12
14
10
14
8
14
*
12
*
15
30
14
14
14
12
10
15
