Idiomas disponibles
Idiomas disponibles
English
1. Installation and setup
We recommend using high quality audio cables to guarantee optimal performance. It is important to ensure that
the speakers stand firmly on a solid surface. Please note that the loudspeakers will need a few days to achieve
optimum sonic performance.
1. Make sure that the volume control of iLoud Precision is set to minimum. Make sure that the ON/OFF switch
on the rear panel is set to OFF
2. Adjust the vertical alignment of the speaker. This step is crucial to fully benefit from the MTM design (for
more information refer to the dedicated paragraph in this manual).
3. Connect the power cord.
4. Connect the audio input source to the input connector of iLoud Precision.
5. Switch ON the ON/OFF switch on the rear panel. The front LED will illuminate steady white after a short
delay.
6. Turn your audio playback system on (Mixing console, Audio interface, etc.). Adjust the volume control to a
lower position only if needed or only in case you require different levels between the speakers.
7. If needed, adjust the speaker response with the dedicated controls on the rear panel.
8. You can perform a speaker calibration to perfectly fit your iLoud Precision into your acoustic environment
(for more information refer to the dedicated paragraph in this manual).
Note: Before plugging in and turning on, remember the "last on, first off" rule of powered speakers. When
powering up your system, be sure that all the wires are connected, turn on your mixer/interface and any other
outboard gear, and then lastly turn on your iLoud Precision. When powering down, turn your iLoud Precision off
first and then your mixer/interface and outboard gear.
10
