Idiomas disponibles
Idiomas disponibles
DISPLAY CONTROL PAD
1. Display interface switching：When the display is powered on, it will show the Current Speed (km/h)
and Trip Odometer (km) by default. Short press i button to switch between Trip Odometer(km),
Odometer (km), Maximum Speed (km/h), and Average Speed (km/h).
2. Assist level: Use plus/minus button to switch the assist level. Power assist is triggered when you
pedal forward, and stops when you stop pedaling, sometime with a delay.
3. Walk Assist Mode: Long press the minus button, the electric bicycle will enter the walk assist mode.
The electrical bike runs at a constant speed of 6 km/h. Release the "-" button, the electric bicycle will
immediately stop power output and return to the state before push.
TURN ON THE LIGHT
By pressing and holding the light button on the right-hand side, the controller will turn on/off the
headlight.
ELECTRIC MODE
You do not need to pedal the e-bike if you use the hand throttle. The throttle can be controlled by twisting
it from the resting position, and the farther the throttle switch is from resting position, the more power is
sent to the motor to accelerate the e-bike. The hand throttle can be removed if you don't need it or
due to local law restriction.
CRUISE CONTROL
Cruise control will be triggered when you holding thumb throttle and riding at the same speed for 8
seconds, and it will be released by braking/pedaling or throttling.
ERROR CODE
If there is a fault occurs in the electronic system of the electric bicycle, the display will automatically show
an error code, see below for a detailed definition of the error code.
Error code
Definition
E021
Current failure
E022
Throttle failure
E023
Motor phase failure
EN
Error code
Definition
E024
Hall failure
E025
Brake failure
E030
Communication failure
17
