FAFREES F20 Master Manual Del Usuario página 16

(110/240-volt plug) to the power outlet. Charging should initiate and will be indicated by the LED charge
status light on the charger illuminating as red light.
5. Unplug the charger from the outlet, then the charging port: Once fully charged, indicated by the
charging indicator light turning green, unplug the charger from the wall outlet first and then remove the
charger outlet plug from the battery charging port.
BATTERY CHARGING INFORMATION
Check the charger, charger cables, and battery for damage before beginning each charge.
Be sure to charge in an area where it is clear and safe from any potential damage or tripping situations
can occur while it is charging. Always charge your battery in temperature between 0℃– 40℃ (32℉–
104℉).
The battery can be charged on or off the bike. To remove the battery, turn the key to the unlocked
position, and take the battery out.
The battery should be recharged after each use, so it is ready to go the full range for your next ride.
There is no memory effect, so charging the battery after short ride will not cause damage.
The indicator light on the charger will show red light while the battery charges. When charging is
complete, the indicator light will turn green. Ensure the light faces upward when charging.
Remove the charger from the battery within one hour of the green light indicating a complete charge.
The charger is designed to automatically stop charging when the battery is full, but unnecessary wear of
the charging components could occur if the charger is left attached to the battery and a power source for
longer than 12 hours.
DO NOT leave a charging battery unattended.
Failure to follow Battery Charging Information could result in unnecessary wear to the
charging components, battery, and or charger, and could lead to an under-performing
or non-functional battery and replacement will not be covered under warranty.
REMOVING THE BATTERY
INSTALLING THE BATTERY
Ensure the battery is turned off.
DO NOT force the battery into the tray; slowly align and gently push the battery down into the tray. Then
push the battery in (make sure you push hard enough) and hear the "CLICK" sound. Slightly turn the key
EN
To remove the battery from the bike, insert the key and turn to the unlocked
position. When the battery is completely locked, you can feel resistant while
turning the key.
Use caution to avoid damage to battery connector terminals,
which are exposed when the battery is unlocked and removed
from the frame of the bike. In the case of damage to the
terminals or battery mounts, please discontinue use and contact Fafrees
Support immediately.
13