Idiomas disponibles
Idiomas disponibles
FUNCTIONS
IDENTIFICATION OF THE PARTS
SENSOR CALIBRATION
If the scooter is deflected left or right when you roll the scooter, you can
calibrate it. For them follow the following steps:
1: Stop the scooter. Place it on level ground.
2: Press the Power button for more than 10 seconds until you see the light
blinking 5 times.
3: Turn off the scooter.
4: Turn it on again and the calibration will be done.
GENERAL OPERATION
The scooter's propulsion system consists of dynamic balancing, using an
internal gyroscope and acceleration sensors.
It is controlled by altering the center of gravity of the same so that the
servo control of each motor acts when tilting each of the parts, forward or
backward. To advance, tilt the two parts forward. To tilt back both sides
back. To turn in the same place incline one part forward and one back.
Each part has an independent motor that allows to describe turns or
changes of direction.
