Parkside Performance PKHAP 20-Li C3 Traduccion Del Manual De Instrucciones Originale página 20

Checking the battery charge level
♦ Press the battery charge level button 6 to
check the charge level of the battery.
The status/remaining charge will be shown on
the battery display LED 7 as follows:
RED/ORANGE/GREEN = maximum charge/
performance
RED/ORANGE = medium charge/performance
RED = low charge – charge the battery
Use
Additional handle
NOTE
► For safety reasons, you should never use this
appliance without the additional handle 0
attached.
♦ Remove the additional handle 0 by turning it
in a clockwise direction (see fold-out page).
♦ Turn the additional handle 0 to the desired
position.
♦ Fix the additional handle 0 in the new position
by turning it anticlockwise.
Depth stop
Undo the screw on the depth stop e.
♦
♦ Insert the depth stop r into the additional
handle 0.
♦ Ensure that the toothing on the depth stop r
is facing downwards.
♦ Pull the depth stop r out until the distance
between the tip of the drill and the tip of the
depth stop corresponds with the required
drilling depth.
Tighten the screw on the depth stop e to
♦
lock the depth stop r into place.
Tool/chuck
♦ Grease the tool holder q slightly before
inserting the tool.
♦ Check that the tool is properly locked by pulling
it. The system has radial play because of the
design.
8
GB │ IE
■ │
Removing a tool
♦ Pull the locking collar w backwards and
remove the tool.
Operation
Select operating mode
WARNING!
► Do not press the function selector switch 1
until the appliance has come to a complete
standstill. Switching between functions while
the tool is still rotating can damage the appli-
ance.
Function selector switch
♦ Press and hold the release button
function selector switch 1. Turn the function
selector switch 1 so that the required symbol
engages at the arrow mark:
Function
Drilling
Hammer drilling
Chisel position adjustment
Chiselling
Adjusting the chisel position
You can rotate the tool to the required position for
chiselling using this function.
♦ Turn the function selector switch 1 to the
position.
♦ Turn the tool in the tool holder q to the
required position.
♦ Turn the function selector switch 1 to the
position for the chiselling function.
Switching on and off
Switching the appliance on
♦ Press the ON/OFF switch 2.
Switching the appliance off
♦ Release the ON/OFF switch 2.
on the
Symbol
PKHAP 20-Li C3