Idiomas disponibles
Idiomas disponibles
•
Before changing the attachments, the appliance must be disconnected from the mains!
•
In order to avoid splashing, always insert the rods fully into the food being mixed before
you switch the mixer on.
•
Only mix or whisk food with this machine.
•
Do not operate the mixer for more than minutes! Then let it cool down for approximate-
ly 10 minutes before using it again!
•
The device is only designed for small quantities! You should therefore only fi ll the
maximum quantities stated in the table into a container!
1 Mains lead
2 5-position switch
3 EJECT button
4 Mixer
•
Ensure that the machine is not connected to the mains.
•
Before initial use we recommend that the dough hooks and whisks should be cleaned in
soapy water.
Assembly of the Kneading Hook/Beater
Press the two whisks and dough hooks lightly on the bottom until they lock into place.
Warning:
The dough hook marked with the ring has to be inserted into the opening (7) of the mixer
that is marked "dough hook"!
It does not matter which whisk is inserted into which opening.
1. Please ensure that the speed switch (2) is turned to „OFF".
2. Connect the mixer to a properly installed power socket, 230 V, 50 Hz.
3. Insert the kneading hook or whisk into the food to be mixed. Set the desired speed with
the speed switch (2). Begin at a low speed (level 1-2) and then increase this if necessary.
4. Tilt the machine slightly up and down.
5. Always turn the device off before removing it from the vessel.
Note:
For optimum results use high-walled vessels that are not too large.
05-HM 3014 N CTC 39
3
Overview of the Components
5 Beater
6 Kneading hook
7 Opening for the marked
Initial Operation
Using the Machine
kneading hook
08.08.2007, 8:43:12 Uhr
GB
39
