Idiomas disponibles
Idiomas disponibles
• ANSI S12.6 (S3.19) hearing protection,
• NIOSH/OSHA/MSHA respiratory protection.
Warning:
Some dust created by power sanding, sawing, grinding, drilling, and other
construction activities contains chemicals known to the state of california to cause cancer,
birth defects or other reproductive harm. Some examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry products, and
• arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you do this type of work. To reduce
your exposure to these chemicals: work in a well ventilated area, and work with approved safety
equipment, such as those dust masks that are specially designed to filter out microscopic particles.
• avoid prolonged contact with dust from power sanding, sawing, grinding, drilling, and
other construction activities. Wear protective clothing and wash exposed areas with
soap and water. Allowing dust to get into your mouth, eyes, or lay on the skin may promote
absorption of harmful chemicals.
Warning:
Use of this tool can generate and/or disperse dust, which may cause serious and
permanent respiratory or other injury. Always use NIOSH/OSHA approved respiratory protection
appropriate for the dust exposure. Direct particles away from face and body.
Warning:
Do not operate this tool for long periods of time. Vibration caused by the
operating action of this tool may cause permanent injury to fingers, hands, and arms. Use
gloves to provide extra cushion, take frequent rest periods, and limit daily time of use.
Warning:
When not in use, place tool on a stable surface where it will not move
inadvertently, roll or cause a tripping or falling hazard. The tool may stand upright on the
battery pack but may be easily knocked over. Serious personal injury may result.
cautiOn:
to reduce the risk of personal injury, use extra care when working into a
corner or edge because a sudden, sharp movement of the tool may be experienced when the
wheel or other accessory contacts a secondary surface or a surface edge.
• When using an extension cord, be
sure to use one heavy enough to carry
the current your product will draw. An
undersized cord will cause a drop in
line voltage resulting in loss of power
and overheating. The following table
shows the correct size to use depending
on cord length and nameplate ampere
rating. If in doubt, use the next heavier
gage. The smaller the gage number, the
heavier the cord.
SyMbOlS
The label on your tool may include the following symbols. The symbols and their definitions are as follows:
V .................. volts
Hz ................ hertz
min .............. minutes
or DC ... direct current
................ Class I Construction
(grounded)
................ Class II Construction
(double insulated)
............ Read instruction manual before use
................ Use proper eye protection
SPM ............Strokes per minute
Minimum gauge for cord Sets
Volts
120V
0-25
(0-7,6m) (7,6-15,2m) (15,2-30,4m) (30,4-45,7m)
240V
0-50
(0-15,2m) (15,2-30,4m) (30,4-60,9m) (60,9-91,4m)
ampere rating
More Not more
Than Than
0 -
6
18
6 -
10
18
10 -
12
16
12 -
16
14
A ...................amperes
W ..................watts
or AC .......alternating current
n o..................no load speed
..................earthing terminal
................safety alert symbol
.../min or rpm...revolutions or
reciprocation per minute
..................Use proper respiratory protection
..................Use proper hearing protection
3/8 -11 ............. Arbor size and Thread count per inch
5
total length of cord in feet
26-50
51-100
51-100
101-200
American Wire Gauge
16
16
16
14
16
14
12
Not Recommended
101-150
201-300
14
12
12
