MecPower Tecway G3 Manual De Instrucciones página 5

Step 2
Unscrew the bolts on both sides of the movable roller and move the roller to the appropriate
position based on the size of the engraving object. Ensure that the two ends of the movable roller
are adjusted to the same calibration value and the two rollers are parallel, then tighten the bolts to
secure the movable roller in place.
Loosen the bolts of the timing belt and pull the timing belt backward until it is in a taut state. Then
tighten the bolts of the timing belt to secure it.
Step 3
Place the engraving machine and the Rotary Roller based on the diagram below. Disconnect the
Y-axis motor cable and connect it to the female connector of the data cable, ensuring that the
terminal is facing in the direction shown in the diagram.
03
EN