FCC Statement
FCC Supplier's Declaration of Conformity
Unique identifier:
DXPAEV040
Responsible party:
Paragon Group USA LLC, 100 West
Forest Avenue, Unit A, Englewood,
NJ07631, USA
U.S. contact
Paragon Group USA LLC, 100 West
information:
Forest Avenue, Unit A, Englewood,
NJ07631, USA
Email:
FCC Interference Statement
NOTICE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules� These limits are designed to provide reasonable protection
against harmful interference in a residential installation� This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to ratio communications� However, there is no
guarantee that interference will not occur in a particular installation� If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
•
Reorient or relocate the receiving antenna�
•
Increase the separation between the equipment and the receiver�
•
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected
•
Consult the dealer or an experienced radio/TV technician for help�
NOTICE: Per FCC Part 15, changes or modifications to this
equipment not expressly approved by D
authority to operate this equipment�
Canada IC Notice
This device contains licence-exempt transmitter(s)/receiver(s) that
comply with Innovation, Science and Economic Development
Canada's licence-exempt RSS(s)� Operation is subject to the
following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference
that may cause undesired operation of the device�
This equipment complies with Industry Canada radiation exposure
limits set forth for an uncontrolled environment�
This Class B digital apparatus complies with Canadian CAN
ICES-003(B) / NMB-003(B) standard�
Service Information
Whether you need technical advice, repair or genuine factory
replacement parts, contact the manufacturer at 1-855-815-1171 or
support@dewaltevcharger�com�
Three Years Limited Warranty
The manufacturer warrants this product against defects in material
and workmanship for a period of three (3) years from the date of retail
purchase by the original end-user purchaser ("Warranty Period")�
If there is a defect and a valid claim is received within the Warranty
Period, the defective product can be repaired, replaced or refunded,
without charge, in the following ways: (1) Return the product to the
manufacturer for repair, replacement or refund at manufacturer's
option� Proof of purchase may be required by manufacturer� (2)
Return the product to the retailer where product was purchased
for an exchange (provided that the store is a participating retailer)�
Returns to retailer should be made within the time period of the
retailer's return policy for exchanges only (usually 30 to 90 days after
the sale)� Proof of purchase may be required� Please check with
the retailer for their specific return policy regarding returns that are
beyond the time set for exchanges�
This warranty does not apply to: accessories, bulbs, fuses and
batteries; defects resulting from normal wear and tear, accidents;
damages sustained during shipping; alterations; unauthorized use or
repair; neglect, misuse, abuse; and failure to follow instructions for
care and maintenance for the product�
This warranty gives you, the original retail purchaser, specific legal
rights and you may have other rights which vary in certain states or
provinces� This product is not intended for commercial use�
90 DAYS Refund Policy
If you are not completely satisfied with the performance of this
product for any reason, you can return it within ninety (90) days from
the date of purchase with a receipt for a full refund�
Please visit our website: www�dewalt�com to register your new
D
special offers�
Specifications
WALT could void your
E
10
WALT product and to be kept up to date on new products and
E
Model:
DXPAEV040
Rated input/output
Nominal 240 V~ single-phase
voltage:
Rated frequency:
60 Hz
Rated current:
40A
Rated charging power:
9.6 kW
Rated standby power:
Max. 5W
Configurable current:
40A, 32A, 24A, 16A
Terminal blocks:
8 AWG, copper only
Grounding scheme:
Level 2
Charging connector:
SAE J1772 standard compliant
Power plug type:
NEMA 14-50
Compatible outlet:
NEMA 14-50
Cable length:
25 ft (7.6 m)
Enclosure rating:
Type 4
Means of disconnect:
External branch circuit breaker
Ground fault circuit
Integrated, no additional required
interrupter:
(CCID20)
Wi-Fi:
2.4 GHz, 802.11b/g/n
Agency approvals:
CSAus
Altitude:
≤1.24 miles (≤2000 m)
Operating temperature:
-22 °F to + 122 °F
(-30 °C to + 50 °C)
Storage temperature:
-22 °F to + 122 °F
(-30 °C to + 50 °C)
Relative humidity:
≤95% RH, no water droplet
condensation
NEMA rating:
Type 4
Net weight:
18 lbs (8.2 kg)
Dimensions W x D x H
11.1 x 7.4 x 17.3"
(main unit):
(28 x 18.9 x 44 cm)