Oursson BL0610G Manual De Instrucciones página 11

PRODUcT SET
Measuring cup ......................................................... 1 pc.
Lid ............................................................................ 1 pc.
Blender's jar ............................................................ 1 pc.
Blades...................................................................... 1 pc.
Rubber gasket ......................................................... 1 pc.
Motor unit................................................................. 1 pc.
Instruction manual ................................................... 1 pc.
ELEmENTS OF DESIGN, Fig. B
Measuring cup
Lid
Blender's jar
Rubber gasket
Blades
Motor unit
Rotary switch
UTILIZATION, Fig. C
control panel, Fig. C-1
Rotary knob – use for following functions:
* «O» - Switching the device OFF.
* 1-5 - Switching the device ON/hanging the speed
level from 1 up to 5, where 1 – minimal speed, and 5 –
maximal.
– use this button to turn on turbo mode
Before first use, make one preparation cycle without
ingredients, add water into the glass jar. After that, wipe
the body of the device with a dry soft cloth. Wash the
jar, lid, mill, stainless steel blades with warm water with
detergents.
Before assembling and disassembling the device,
make sure it is unplugged.
Utilizing the jar:
The blades are very sharp, be careful.
1. Place the jar onto the motor unit according to the
manual, Fig. C-2, C-3.
2. Add ingredients. Do not fill the jar above the max.
mark, Fig. C-4, C-5.
3. Plug in the device.
4. Select the required speed, using the knob, from 1 to
5, turning it clockwise. The Mix/Grid process will start
automatically.
5. You may also turn on the blender by turn the knob to
position. In this case, the device will be working at
maximum speed all the time. To turn off the device,
turn the knob to position «O».
NOTE: To get ice crumb, select the maximum speed
level, or turn the knob to
the pieces are still big, repeat the operation.
6. To finish working with blender, turn the knob to «O»
position. Unplug the device.
7. After that you can disassemble the device. You
can open the lid only when the jar is removed.
Before placing the jar, make sure that the
knob is in the «O» position.
position for a few seconds. If
11