Idiomas disponibles
Idiomas disponibles
Cool -
Compressor runs and cools the room. Use the
set the desired temperature and circulation fan speed.
Fan
-
Fan circulates air but compressor does not run. Use the FAN button to set
the desired fan speed.
Dry
- Dry mode is used to remove humidity from the room without additional cooling.
Once the set temperature is reached， the compressor and circulation fan turns off.
Fan speed is pre-set and cannot be adjusted.
TEMPERATURE CONTROL
The thermostat monitors room temperature to maintain the desired temperature.
The thermostat can be set between 60 F~86 F (16 C~30 C).
FILTER RESET
'Clean Filter' LED will light up to notify you that your filter needs to be cleaned.
After cleaning the filter, press 'Filter Reset' button to turn off ' Clean Filter' light.
This feature is reminder to clean the Air Filter (See Maintenance) for more efficient operation.
The LED (light) will illuminate after 250 hours of operation.
During operation in failure of electric power, the unit runs as previous setting operation.
ENERGY SAVER
The unit defaults to Energy Saver mode each time the unit is switched on except
restoration after an electrical power outage and fan mode.
1. Push out the cover on the back of the remote control with your thumb.
2. Pay attention to polarity and insert one new AAA 1.5V battery.
3. Reattach the cover.
Do not use rechargeable battery. Make sure that the battery is new.
Do not mix alkaline, standard (Carbon-zinc) or rechargeable (Nickel-cadmium)
batteries.
- In order to prevent discharge, remove the battery from the remote control if
the air conditioner is not going to be used for an extended period of time.
Keep the remote control away from extremely hot or humid places.
To maintain optimal operation of the remote control, the remote sensor should
not be exposed to direct sunlight.
and FAN buttons to
y
17
