Idiomas disponibles
Idiomas disponibles
TECHNICAL DATA
Lifting capacity: max. 25 / 50 tons
Working pressure: 8 - 12 Bar
Lifting range: 165 - 330 mm
Saddle length: 40 / 60 mm
Cylinder diameter: 136 mm
Weight: 35 kg
ATTENTION
Read the operating instructions and all safety instructions contained therein carefully before using the
product. Use the product correctly, with care and only according to the intended purpose. Non-
compliance of the safety instructions may lead to damage, personal injury and to termination of the
warranty. Keep these instructions in a safe and dry location for future reference. Enclose the
operating instructions when handing over the product to third parties.
INTENDED USE
This jack is used for lifting vehicles. The jack must be used on a flat surface witch can support the
load. This product is for indoor use only, witch protected from rain, wind or moisture. It is not allowed
to lift people. The product weight and the maximum weight of the load to be lifted are specified in this
manual. This tool is not designed to work under the vehicle. Failure to comply with the intended use
can lead to significant risks for the user and is his sole responsibility. The product may only be used
as intended. The user must comply with safety and prevention standards. We assume no
responsibility for personal injury or property damage resulting from misuse of the pneumatic jack.
SAFETY INFORMATIONS
•
Keep children and other persons out of the working area.
•
Do not allow children to play with this tool or its packaging.
•
The jack must be used by trained and authorized people.
•
It is forbidden to lift people with this product.
•
Check the load, especially when it is going up, while ensuring there is no anomaly. If any
problem happens, the pneumatic balloon jack must go down as soon as possible and place
the vehicle correctly.
•
Clean the vehicle supporting surface.
•
This product is a lifting tool only. After lifting the vehicle, it must be support by safety links.
•
Do not position the saddle under an area next to airbags sensors or plastic surface.
•
Check the compressed air supply, the pressure in the compressed air system must not exceed
the working pressure specified in the chapter "Technical data".
•
Systematically lower the load down to the ground if leaving the device for a long period of time.
•
The vehicle weight must not exceed the maximum load specified in the chapter "Technical
data".
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Air hydraulic Jack 25/50 t
Tel.: 02196 720480
Fax.: 02196 7204820
BGS 74287
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
