Idiomas disponibles
Idiomas disponibles
OPERATION
1. Hold the handle of the brake and adjust the angle of the grip rod (fig.1).
2. When not using and saving space, adjust the grip rod to 90 degrees and fold the folder to save
space (fig.2).
3. When moving the jack, adjust the grip rod to 45 degrees so that people can push and pull the
jack (fig.3).
4. When aligning the working position, adjust the grip rod to the horizontal direction, and adjust the
position of the jack around and around (fig.4).
5. Connect the air source well when lifting. The inner diameter of the air line should be over 8 mm
(fig.5).
6. Adjust the three gears on the switch as needed (fig.6).
7. The saddle should be added in every use so as to avoid the damage of the cylinder caused by
the direct contact between the car body and the cylinder (fig.7).
LIFTING CAPACITY
Maximum lifting capacity: 50 tons
hydraulic piston (1)
begins to lift
1
LIFTING
1. Ensure the vehicle manufacturer's recommended lifting point for the vehicle is stable and properly
centered on the saddle.
2. Raise the jack to the desired height.
3. After lifting the vehicle, secure it with jackstands.
4. Lower the jack to lower the vehicle onto the jack stands.
5. After completing the process and before starting work on the vehicle, make sure that you have
checked the stability of the vehicle.
LOWERING
1. Before lowering the jack always make sure that no objects are under the vehicle.
2. Raise the vehicle as described in the chapter "Lifting" and remove the jack stands.
3. Slowly lower the jack to its lowest position.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
Maximum lifting capacity: 25 tons
hydraulic piston (2)
begins to lift
1
2
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
