Idiomas disponibles
Idiomas disponibles
HDL 1400
Barbecue grills, electrical equipment and garden tools
Rinse with fresh water. If you use detergent, fill the tank and apply it to the area being cleaned at low pressure. Let the
detergent sit on the surface for a few minutes, but do not let the detergent dry out. High pressure rinse at a minimum
distance of 3cm to 8cm from the cleaning surface. Keep a greater distance from the cleaning area when using a direct
spray.
TROUBLESHOOTING TIPS
THE SWITCH IS IN THE "I" POSITION AND THE MACHINE DOES NOT START
CAUSE
The power socket is faulty
The voltage is inadequate
The power cord is not plugged in
THE PUMP DOES NOT REACH THE PROPER PRESSURE OR FLUCTUATES
CAUSE
The water inlet filter is clogged
Pump sucks air
Suction valves are clogged or worn
Garden hose diameter too small
The water supply is restricted
Insufficient water supply
THE PRESSURE WASHER DOES NOT HAVE OR DOES NOT MAINTAIN PRESSURE
CAUSE
Excess air in water line and pump
PRESSURE WASHER MAKES EXCESSIVE NOISE
CAUSE
Intake is blocked
Valves are worn, dirty, or clogged
The filter is dirty
MOTOR STOPS WORKING WHILE IN USE
CAUSE
Input voltage lower than necessary
POSSIBLE SOLUTION
Check the plug, power socket and fuses
Check if the voltage is adequate
Plug in the power cord
POSSIBLE SOLUTION
Remove and clean the filter
Tighten connections/bleed system
Clean or replace valves
Replace with ¾-inch garden hose
Check that the hose is not kinked or leaking
Water source fully open
POSSIBLE SOLUTION
Turn off unit and water supply/
Purge System/Hold Trigger
POSSIBLE SOLUTION
Check intake valves
Check, clean, or replace valves
Check, clean or replace the filter
POSSIBLE SOLUTION
Check if the voltage is adequate
27
