Idiomas disponibles
Idiomas disponibles
HDL 1400
WARNING: never use products with bleach, chlorine or any other corrosive material, including liquids containing
solvents (ie gas, oils, etc.), tri-sodium phosphate, ammonia or acid-based products. These chemicals will damage the
unit and cause damage to the surface being cleaned.
CLEANING AND STORAGE
When you are finished using the pressure washer, follow these steps to put it away:
• Put the switch in the OFF position.
• Close the water supply.
• Before disconnecting the hose, point the gun in a safe direction and discharge any remaining water.
• Disconnect hose, pressure washer, and gun.
• Disconnect the hose from the water supply.
• Remove excess water from the pump by tilting the unit on both sides to drain remaining water from the inlet and
outlet fittings.
• Remove the water inlet filter and rinse it with water to remove any dirt or debris. Replace the filter once clean.
• Empty the detergent tank and rinse it with clean water.
• Clean any remaining water from all parts and accessories.
• Activate the gun safety lock.
• Store the pressure washer, parts and accessories in an area with a temperature above 0°C (32°F).
MAINTENANCE
• This pressure washer is supplied with a closed lubrication system, so it is not necessary to add oil.
• Check all hoses and fittings for damage before use.
• Periodically check the inlet filter for deposits. Clean this filter regularly for maximum performance.
CLEANING TIPS
WARNING: ALWAYS TEST THE WATER JET IN A FREE AREA CLEAR OF PERSONS AND OBJECTS BEFORE SPRAYING ON
THE INTENDED CLEANING SURFACE.
Wood and vinyl decking
Rinse the cover and the surrounding area with clean water. If you are using detergent, fill the detergent tank and apply
it to the area being cleaned at low pressure. For best results, reduce your work area to smaller sections and clean each
section one at a time. Let the detergent sit on the surface for a few minutes, then rinse with high pressure. DO NOT
ALLOW THE DETERGENT TO DRY ON THE SURFACE. Always wipe from left to right and top to bottom for best
results. Rinse at high pressure with the fan spray keeping the tip of the spray nozzle a minimum of 15cm to 25cm from
the cleaning surface. Keep a greater distance from the cleaning area when using a direct spray. Caution: For softer
woods, increase the distance from the cleaning area.
Cement, Stone and Brick Patios
Rinse the area with clean water. If you are using detergent, fill the reservoir and apply it to the area being cleaned at
low pressure. High pressure rinse using a fan spray in a sweeping motion keeping the tip of the nozzle a minimum of
15cm to 25cm from the cleaning surface. Keep a greater distance from the cleaning area when using a direct spray.
Cars, Boats and Motorcycles
Rinse with clean water. If using detergent, fill reservoir and apply to area being cleaned at low pressure. For best
results, clean one side at a time. Let the detergent sit on the surface for a few minutes, but don't let it dry. High
pressure rinse using the fan jet in a sweeping motion keeping the nozzle at least 20cm from the cleaning surface. Keep
a greater distance from the cleaning area when using a direct spray. Dry the surface to obtain an optimal finish.
26
