Idiomas disponibles
Idiomas disponibles
USING YOUR CLEANER
There are 4 working modes which you can detect from the colour of the Power Mode LED light.
• STANDARD MODE: When you press ON-OFF button, the cleaner is ready to clean thoroughly with the main motorised
nozzle. The LED light is white. [3a]
• SILENT MODE: Press the Silent Mode button to clean thoroughly at the lowest noise level of this product. The light turns
to green. [3b]
• TURBO MODE: Press the Turbo button to fully power the product for hard cleaning tasks. The LED light is blue. [3c]
• AUTO MODE: When you remove the nozzle or the tube, the product automatically adapts to a lower power for above floor
cleaning, with non-motorised tools. The LED light is light blue/cyan.
BRUSH BAR STATUS
The brush bar status LED on the nozzle will stay illuminated white during all floor cleaning modes and will turn red if the
safety protection system is activated. [14]
Wi-Fi SETUP
NOTE: This product features Wi-Fi connection to enhance your interaction with your cleaner. It allows you to get statistics
on product usage, how best to use and monitor the overall maintenance off your product to guarantee the performance.
Enrollment
You can switch the Wi-Fi On/Off by pressing the Wi-Fi button as shown in the diagram. [3d] The LED light will continuously
flash until the vacuum cleaner is connected to the Hoover Wizard App.
1.
You can download the Hoover Wizard Application by scanning the QR code located on the cover of this manual.
2. Install it on your smartphone.
3. Follow the instructions in the App to setup your vacuum cleaner.
When installed correctly, your smart phone will connect automatically.
RESET Wi-Fi
You can reset your vacuum cleaner by pressing the Wi-Fi button for 5 seconds until the LED light starts flashing.
You need to reconnect the vacuum cleaner to the APP again.
NOTE: once you lock the product by App, you can unlock it both by App or pressing "Turbo" and "Silent" button on the
product for 3 seconds at the same time.
SELECT SUITABLE ROLLER FOR BEST CLEANING
Intense Floor roller*: it is recommended to use on carpet which can go deep into the carpet to clean the dust.
Deep Care roller*: it is recommended to use on hard floor or delicate parquet. Thanks to the soft bristles you can gently
clean those type of floors.
IMPORTANT: Always switch off the cleaner before changing and cleaning the agitator.
NOTE: To fit the Roller you would like to use: [17]
1. Detach the agitator release button flap. It is positioned on the lateral part of the nozzle.
2. Hold the agitator release flap and pull down to remove the agitator.
3. Replace with Intense Floor Roller or with the Deep Care Roller.
4. Re-fit in position the agitator release flap.
WIPER BLADE ASSEMBLY
To obtain the best crevice and carpet performance, it is recommended to assemble the front and rear wiper blades to the
soleplate of the nozzle.
To do this, open the agitator release flap and remove the soft strip. Then grip one wiper blade, by inserting one end into
the rear slot and slide it in until fully home. Repeat these operations for the second wiper blade and slide it in the front slot.
Lock the agitator release flap. [16]
* Certain Models Only
4
GB
