3. Remove the I/O module from the computer.
Installing optional I/O modules (Type C/ HDMI/VGA/DP/
Serial)
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the system board and provide a visual representation of the installation procedure.
Steps
1. To remove the dummy metal bracket, insert a flat-head screwdriver in the hole of the bracket. Push the bracket to release the
bracket, and then lift the bracket out from the system.
2. Insert the optional I/O module into its slot from the inside of your computer.
3. Connect the I/O cable to the connector on the system board .
4. Replace the two (M3X3) screws to secure the optional I/O module to the system.
Next steps
1. Install the
front
bezel.
2. Install the
side
cover.
3. Follow the procedure in
Procesador
Extracción del procesador
Requisitos previos
1. Siga el procedimiento que se describe en
2. Quite la
cubierta
lateral.
3. Quite el
bisel
frontal.
4. Quite el
ensamblaje del
5. Extraiga el
disipador de
Sobre esta tarea
En las imágenes a continuación, se indica la ubicación del procesador y se proporciona una representación visual del procedimiento de
extracción.
44
Desmontaje y reensamblaje
after working inside your
computer.
Antes de manipular el interior de la
ventilador.
calor.
computadora.
