Idiomas disponibles
Idiomas disponibles
FUNCTIONAL DESCRIPTION
2
1
11
12
18
17
16
1. Lifting point
2. Handle locking knobs (2)
3. Control panel
4. Handle
5. Clip
6. Battery lock
7. ONE-KEY™ card
8. Belt guard
9. Transport handles (4) (also on reverse side of tool)
10. Compacting plate
11. Arm button
12. Overload indicator
13. Speed control buttons
14. Forward/Reverse buttons
15. Neutral button (stop)
16. Fuel gauge
17. Low temperature indicator
18. ONE-KEY™ indicator
3
5
6
7
8
9
13
10
Cat. No. ..................................................... MXF220
4
Battery Type ........................................ MX FUEL™
Charger Type....................................... MX FUEL™
Max Recommended Slope Operation ............... 25°
Replacement belt........................................3VX250
Lifting weight............................................. 225 lbs**
Module/FCC ID ............................ BGM11S/QOQ11
Recommended Ambient
Operating Temperature ......................0°F to 125°F
WARNING
cifi c charging instructions, read the operator's
manual supplied with your charger and battery.
Removing/Inserting the Battery
To remove the battery, push the battery latch lock
to the side and squeeze the battery latch lever. Pull
the battery pack away from the machine.
WARNING
To insert the battery, slide the pack into the body of
the machine. Make sure it latches securely into place.
WARNING
manufacturer. Others may be hazardous. Just
because the accessory can be attached to this
machine, it does not assure safe operation.
When the machine is armed, the fuel gauge displays
the battery pack's remaining run time. The fuel gauge
mirrors the fuel gauge on the battery pack. When less
than 10% of charge is left, 1 light on the fuel gauge
will fl ash. When the battery reaches 0% charge, the
fuel gauge will fl ash 8 times. Charge the battery pack.
14
Unfolding/Folding the Handle
CAUTION
control panel during folding and unfolding of the
handle.
15
To avoid the risk of injury, do not operate the
machine with the handle locking knobs unlocked.
For operating position:
1. To unfold the handle, turn both handle locking
knobs to the unlock position (1).
2. Pull the clip away approximately an inch from the
lifting point (2).
4
SPECIFICATIONS
ASSEMBLY
Recharge only with the charger
specifi ed for the battery. For spe-
Always remove battery pack before
changing or removing accessories.
Only use accessories specifi cally
recommended by the machine
Fuel Gauge
Pinch hazard. Keep body parts
away from hinge, lifting point and
