Idiomas disponibles
Idiomas disponibles
Preparing for use/Use
Q
Assembly
Q
Note: Have a vessel filled with approx. 800 ml water ready before
you start assembly.
j
U npack the product and the accessories carefully.
Note: When you are unpacking the components make sure that
you do not unintentionally throw away any of the assembly materials.
j
P lace the water container
face near a mains socket (230-240 V ~ , 50 Hz).
j
M ount the lamp attachment assembly
stone
. To do this, position the lamp attachment
2
over the holes for the lamp attachment
place by screwing in the screws
the bulb"). Use a PH1 screwdriver to tighten the screws.
j
F ill the water container
side wall) of the water container
j
C onnect the pump
nection piece
j
I ncrease (MAX) or reduce (MIN) the flow of water issuing from
the ornamental stone
j
P lace the base
and guide the lead from the pump
12
j
D ecorate the base
j
P ush the pump plug
j
Y our tabletop fountain is now ready for use.
Switching the tabletop fountain on and off
Q
j
P ush the seal
j
I nsert the adapter
on a flat and even supporting sur-
12
with water up to the MAX marking (in-
12
to the connection hose
8
.
15
by means the +/- slider
2
with the attached pump
6
with the pebbles
6
on to the connection plug
9
on to the connection plug
9
into a properly installed mains socket to
11
Preparing for use / Use
on to the ornamental
1
and fix it firmly in
3
(see Figure A and "Replacing
5
.
12
7
on the water container
8
through the recess
8
.
13
.
10
exactly
4
with the con-
(Fig. C).
14
.
16
.
10
GB/MT
49
