Idiomas disponibles
Idiomas disponibles
POSITIONING
Possible placement positions:
In a way that the back side alone is opposite to the wall; be careful that there is a gap of 150
1.
mm (15 cm) between the wall and your device. (Picture 7)
In a way that is place to a corner; when you place it to a corner, leave a gap of 150 mm (15
2.
cm) behind. You can lean the side, corresponding to the corner, to the wall.
The most important point to be considered in all cases of product placement is not to obstruct
•
ventilation of the compressor assembly.
Without exposing your product to any slope, place and operate it in a manner that it is on its feet
•
or wheels. (Picture 8)
The freer the compressor assembly ventilation is, the better the device will run.
•
INSTALLATION
Before positioning, remove and disassemble all packaging materials and bottom wooden pallet
•
of the product. (It may be necessary to lift your device for removing the bottom pallet).
Insert the replacement parts inside your product according to the installation instructions. Only
•
use genuine spare parts. Please consult to salesperson for minimum period during which spare
parts, are available
Inauthentic spare parts may constitute danger for you and damage your product.
•
Place the product anywhere you desire. Consider the placement rules written in the manual
•
while positioning the product.
Balance your product in width and in depth by means of a water gauge. Please perform optional
•
balancing operation by means of the adjustable feet at the bottom front of your product. (Picture
9)
PICTURE 7
PICTURE 9
PICTURE 8
48
