Idiomas disponibles
Idiomas disponibles
BEFORE INSTALLATION
Place the product at least one (1) meter away from heat resources (stove, radiator, electric
•
heater etc.). (Picture 5)
Do not place it opposite to the air conditioner chutes, under fans and direct door and window
•
openings. (Picture 6)
Do not expose to direct sunlight. Operation ratio will increase if sunlight comes to your product's
•
glass. That means an increase in the energy consumption.
Air intake and outlet must absolutely be fluent and free for proper operation of the compressor
•
section of your product.
While approaching your product to the wall, be careful that there is a gap of 150 mm (15 cm)
•
between the wall and back of your device.
WARNING!
In very humid environments, ensure that floor and wall of the place where your product is
•
located, is not affected by water; against discharge water overflow danger.
In installations performed by an authorized person, they can inform the consumer on the suitable
•
place for installation and make suggestion, but the consumer shall give the final decision on
where the installation will be made. This above-mentioned process shall also be stated on the
relevant installation form by Authorized Service. In case of any loss arising from the place of
installation of the product according to the final decision given by the consumer, all responsibility
related to such loss shall belong to the consumer.
Your product gives the best cooling performance according to the climate condition under the
•
conditions given below.
Therefore, be careful that the temperature of the environment where your product will operate
•
is at these levels.
Climate Class
CC1
CC2
4
Temperature Range
25ºC
32ºC
30ºC
PICTURE 5
Humidity
60% Rh
65% Rh
55% Rh
47
PICTURE 4
PICTURE 6
