Idiomas disponibles
Idiomas disponibles
EN
11.5 - Operation in Output mode
RAD INT
A
command causes opening of the door, which
remains open for a user-modifiable duration time (see Changing
parameters) and then closes again.
11.6 - Operation in Input mode
RAD Est
A
command causes opening of the door, which
remains open for a user-modifiable duration time (see Changing
parameters) and then closes again.
11.7 - Operation in Partial Opening mode
RAD INT
RAD Est
A
or
the opening stroke is reduced to a percentage of the maximum
stroke that can be changed by the user (see Changing parameters).
The door remains open for a user-modifiable duration time (see
11.8 - Operation in Open mode
Positioning the selector in the Open position causes opening of
the door, which remains open until the position of the selector is
changed.
11.9 - Operation in block mode
Positioning the selector in the Lock position causes closing of
the door and subsequent activation of the electric lock. The
door remains closed and locked, ignoring any command (except
11.10 - Operation in Pharmacy mode
Positioning the selector in the Pharmacy position results in closing
of the door and subsequent activation of the electric lock. Only the
START
OPEN
,
and
11.11 - OPEN and CLOSE commands
OPEN
The
command results in opening of the door, which remains
CLOSE
open until the
EST
command during closing results in immediate reopening.
OPEN
CLOSE
The
and
cause opening or closing of the door, which remains open/closed
11.12 - START command
START
The
command results in opening of the door even in a
locked state. The door remains open in the manner defined by
parameter U (see Changing parameters) and then closes and
locks (only if the lock status persists). By changing the parameter
11.13 - STOP command (N.C.)
The STOP command results in immediate stopping of the door
and, as long as it remains active, any other command is ignored.
11.14 - PHOTO command (N.C.)
PHOTO
The
command causes the door to reopen if in the closing phase and, as long as it remains active, it does not allow it to be closed again.
70
command causes opening of the door;
CLOSE
commands are accepted. The door
RAD INT
command is received. A
command are priority commands, they
RAD INT
RAD Est
A
or
RAD INT
command during closing causes immediate reopening.
RAD INT
RAD ESt
A
or
RAD ESt
command during closing causes immediate reopening.
Changing parameters) and then closes again. A
Est
command during opening is ignored.
RAD INT
A
or
immediate reopening.
Note: in this mode the "
STOP
STOP
the door. The "
START
) until the position of the selector is changed.
opens only approximately 15 cm and the electric lock is activated
again when closed. This condition remains until the position of the
selector is changed.
for the entire duration of the command.
RAD
or
During the opening or closing performed with the maintained
OPEN
CLOSE
or
commands, a
command is ignored.
PHOTO
A
command during closing results in immediate reopening.
"U" to position 0 (zero) it becomes "step-by-step".
Note: this mode does NOT follow the "PARTIAL OPENING"
setting, therefore the "
completely.
OPEN
Except in the "
command during opening is ignored. A
command during opening is ignored. A
RAD INT
RAD ESt
command during closing causes
CLOSE
CLOSE
" command closes and reopens
" command stops the door.
RAD INT
RAD EST
or
START
START
" command always opens
" functionality.
RAD
or
or START
