Idiomas disponibles
Idiomas disponibles
Note: Automatic changeover is only possible under certain conditions.
See "FUNCTION PARAMETER SET"» "AUTO MODE SET" in "Installation and owner's manual".
Adjust space operation mode by the room thermostat, see "FUNCTION PARAMETER
SET"»"ROOM THERMOSTAT" in "Installation and owner's manual ".
Go to"
"»"OPERATION MODE SET", if you press any key to select or adjust, the page will
appear:
6 OPERATION
6.1 OPERATION MODE SET
See "5.4 Adjusting space operation modes".
6.2 TEMP. CURVE SET
TEMP. CURVE SET function is used to preset the desired water flow temperature depending on
the outside air temperature. During the warmer weather the heating is reduced. To save energy,
TEMP. CURVE SET can decrease the desired water flow temperature when the outdoor air
temperature increased in heating mode.
Go to "
" » " TEMPERATURE PRESET " » "TEMP. CURVE SET". Press "OK".
The following page will appear:
TEMP. CURVE SET
LOW TEMP. FOR ZONE-A COOL
HIGH TEMP. FOR ZONE-A HEAT
LOW TEMP. FOR ZONE-B COOL
HIGH TEMP. FOR ZONE-B HEAT
This page will be displayed dynamically based on operation mode and device type and zone number.
4
6
4
6
16
